 | |
| Illustration 1 | g00868704 |
A junction box is located to the right of the operator control panel.
Push in the reset button. This will reset the circuit breakers. If the system is operating properly, the button will stay depressed. If the button does not stay depressed, you should check the electrical circuits.
Engine Start Relay (1) - 10 amp
Alternator Circuit Breaker (2) - 80 amp
Main Circuit Breaker (3) - 80 amp
Roading Lights, Work Lights, Flasher, Turn Signals, and Hazard Lights (4) - 15 amp
Light Switch, Brake Pressure Switch, and Tail Lights (5) - 10 amp
 | |
| Illustration 2 | g00868730 |
Note: Throttle Controller, Back Up Alarm, Horns, Rotor Brake Release Solenoid, Rotor Service Switch, Horn Switch, Rotor Door Switch, Propel Axle Lock Switch, Propel Axle Lock Solenoid, Rotor Hood Tilt Switch, Hourmeter, Electric Hydraulic Pump motor Relay, Rear Door Raise and Lower. Solenoids (6) 15 amp.
Cab (7) - 15 amp
Cab (8) - 15 amp
Cab (9) - 15 amp
Cab and Air Conditioning Compressor (10) - 20 amp
Note: ECM, Steer Mode Sensor, Position Sensor for the wheels,Rear Steer Switch, Propel Sensor, Engine Speed Sensor, Parking Brake, Rotor Depth Sensor,Lift Lock Switch, Foot Brake Pressure, Rotor Solenoid Switch, Rotor Depth Mode, Rotor Control, Rotor Depth Indicator, Fuel Solenoid, Propel Pump Solenoid, Parking Brake Solenoid, Rotor Control Solenoid, Steering Solenoid, Rotor Brake Solenoid.
Rotor Speed Sensor Switch (11) - 15 amp
Additive System (12) - 15 amp
Rear Wheel Drive, and the Pump Motor for the Electro-Hydraulic Rotor Brake Service (13) - 20 amp
Caterpillar Monitoring System Control, Caterpillar Monitoring System Master Lamp, Mode Selector Switch, Fuel Level Sender, Engine Coolant Temperature Sensor, Transmission Oil Temperature Sensor, Hydraulic Oil Temperature Sensor, Engine Oil Pressure Sensor, Left Turn Signal, Right Turn Signal, Caterpillar Monitoring System Alarm, Four-Way Hazard Switch, Diagnostic Switch, Transmission Filter Switch, and Differential Lock (14) - 10 amp
Rotary Beacon, Switch for the Rotary Beacon, Service Light, Release for the Auxiliary Brake, and Propel and Full Enable (15) - 15 amp
High Idle Relay (16) - 30 amp