General Information
C-9 发动机为直列六缸布置。 发动机的点火顺序为 "1-5-3-6-2-4"。 当从发动机的飞轮端观看发动机时,发动机的转向为逆时针。 发动机采用涡轮增压器。 发动机的缸径为 112 mm (4.4 in),冲程为 149 mm (5.9 in)。 排量为 8.8 L (537 in3)。
C-9 发动机利用液压电子式单体喷油器(HEUI)进行喷油。 HEUI 消除了泵和油路系统内使用的许多机械部件。 HEUI 也加强了对正时和燃油空气混合的控制。 通过精确控制单体喷油器正时获得正时提前。 发动机转速由调整喷油持续时间来控制。 通过特殊的脉冲轮为电子控制模块(ECM)提供气缸位置和发动机转速检测信息。
发动机具有内置诊断,以便确保所有部件正常工作。 如果系统部件出现故障,可以通过仪表板上的检查发动机指示灯提醒操作员这个状况。 电子维修工具可用于读取出针对有故障的部件或状况的数字编码。 此外,巡航控制开关也可用于在检查发动机指示灯上闪烁代码。 间歇性故障会记录和储存在存储器内。
起动发动机
发动机 ECM 将自动提供起动发动机所需的正确燃油量。 发动机盘车中不要踩下油门。 如果发动机 20 秒内没有起动,应松开起动开关。 再次使用起动马达前,让起动马达先冷却两分钟。
Show/hide table
注意 |
---|
选装的自动乙醚喷射系统是唯一推荐使用的起动液系统。 乙醚过量使用会造成活塞和活塞环损坏。 只能在冷天起动时使用辅助起动液(乙醚)。 |
寒冷天气起动
寒冷天气发动机的起动和运转性能取决于燃油类型、机油粘度和其它选装的起动辅助装置。 更多有关资料,请参阅操作和保养手册, "寒冷天气操作"专题(操作部分)。
Caterpillar Information System:
TH103 Telehandler Capacities (Refill)
Caterpillar<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> AP-900B and Barber-Greene<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> BG-240C Asphalt Pavers 3116 Engine Supplement Radiator - Remove and Install
216, 226, 232 and 242 Skid Steer Loaders Machine Systems Gear Pump - Install
Caterpillar<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> AP-900B andBarber-Greene<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> BG-240C Asphalt Pavers Gear Motor (Ventilation System) - Disassemble
2003/10/13 New Transmission Gear Position Sensor Available for Off Highway Trucks, Wheel Tractor Scrapers, and Articulated Trucks {1408, 3061}
2001/02/19 Service Parts are Available for the Manifold for the Ejector Cylinder and the Tailgate {5264}
2002/01/28 Improved Coolant Flow Switches Are Available {1438}
3306B-XQ200 Rental Generator Set Engine Enclosure - Inspect
2001/04/23 Correction to Testing and Adjusting for the Test of the Torque Limiter {5070}
725 and 730 Articulated Trucks Machine Systems Check and Pressure Reducing Valve (Brake Accumulator) - Install
312C, 315C, 318C, 319C, 320C, 321C, 322C, 325C, 330C and M325C Excavators and 325C MHPU and 330C MHPU Mobile Hydraulic Power Units Engine and Pump Control - V2 Backup System
2001/05/14 An Improved Selector Fork and a New Pressure Control Valve for the Interaxle Differential Lock is now Installed {3074, 3159}
826G Landfill Compactor, 825G Soil Compactor, 824G Wheel Dozer and 980G Wheel Loader Power Train Electronic Control System MID 081 - CID 0190 - FMI 01
CP-663E, CS-663E and CS-683E Paving Compactors Machine Systems Gear Pump (Steering)
725, 730, 735, 740 and 740 EJECTOR Articulated Trucks Power Train Electronic Control System Retarder - Calibrate - Using the Caterpillar Electronic Technician
826G Series II Landfill Compactor, 825G Series II Soil Compactor and 824G Series II Wheel Dozer Articulation Bearings - Lubricate
Caterpillar<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> AP-900B andBarber-Greene<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> BG-240C Asphalt Pavers Gear Motor (Ventilation System) - Assemble
2001/03/05 Reposition the Water Valve for the Cab Heater in order to Reduce the Heat in the Cab {7304}
725 and 730 Articulated Trucks Machine Systems Parking Brake - Remove
TH103 Telehandler Plate Locations and Film Locations
2001/02/19 The Coolant Recovery Bottle Has Been Improved {1351}
826G Series II Landfill Compactor, 825G Series II Soil Compactor and 824G Series II Wheel Dozer Axle Oscillation Bearings - Lubricate
C-9 Engines for Caterpillar Built Machines Basic Engine
C-9 Industrial Engine Gear Group (Front) - Time