Fuel Transfer Pump
Show/hide table
Illustration 1 | g00759652 |
(1) Pressure regulating valve
(2) Inlet port
Show/hide table
Illustration 2 | g00759647 |
(3) Weep hole
(4) Outlet port
Show/hide table
Illustration 3 | g00533385 |
Typical cover opposite the fuel transfer pump |
(5) Nuts
- Tighten the nuts to the following torque. ... 30 ± 5 N·m (22 ± 4 lb ft)
Caterpillar Information System:
2000/12/18 A New Schematic for the Hydraulic System is Available {5050}
424D, 428D and 438D Backhoe Loaders Before Operation
2000/12/01 Correction to Testing and Adjusting Module, SENR5832, Electronic Modular Control Panel II+ (EMCPII+) for MUI Engines {4490}
2000/12/18 Correction to the Disassembly and Assembly Manual for the Brake and Wheel Spindle Housings {4002}
HF181, HF201 and HF221 Felling Heads Output Shaft
3176C Engine for Caterpillar Built Machines User Defined Shutdown Input Circuit - Test
725, 730 and 730 Ejector Articulated Trucks Engine Supplement Radiator - Install
RM-250C Reclaimer Mixer Rotor Chain Drive Hub Breather - Replace
797 Off-Highway Truck Power Train Rear Axle Housing
2000/12/18 Correction to the Special Instruction for the Installation of the Wheel Assemblies {4208, 7960}
725 and 730 Articulated Trucks Power Train Power Train Hydraulic System
725 and 730 Articulated Trucks Power Train Power Train Pressures
725, 730, 735, 740 and 740 EJECTOR Articulated Trucks Power Train Electronic Control System MID 027 - CID 0704 - FMI 03
3176C Engine for Caterpillar Built Machines Ether Injection System - Test
797B Off-Highway Truck Power Train Rear Axle and Final Drive Hydraulic System
725, 730, 735, 740 and 740 EJECTOR Articulated Trucks Power Train Electronic Control System MID 027 - CID 0704 - FMI 04
725, 730, 735, 740 and 740 EJECTOR Articulated Trucks Power Train Electronic Control System MID 027 - CID 0709 - FMI 03
725 and 730 Articulated Trucks Power Train Oil Filter (Transmission)
725 and 730 Articulated Trucks Power Train Transmission Planetary
725 and 730 Articulated Trucks Power Train Interaxle Differential
2000/12/25 Correction to the Special Instruction for the Installation of the Bevel Gear, Differential and the Differential Case {3256, 3258}
416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Machine Systems Lift Arms - Remove
725 and 730 Articulated Trucks Braking System Parking Brake Air - Purge
3176C and 3406E Engines for D7R Series II and D8R Series II Track-Type Tractors Low Power/Poor or No Response to Throttle