End Gates
Show/hide table
 | |
| Illustration 1 | g00727950 |
The end gates are located at each side of the screed. The end gates form the edge of the mat. The end gates are standard equipment. The end gate is always necessary except when you bleed out material to the side. There are two chains that attach to the bottom of the jacks for the end gate. The chains adjust the floating part of the end gate.
Use the following procedure to adjust the chain length to correct the spring tension.
- Lower the screed to the ground.
- Lower the jacks (1) for the end gate until there is slack in the chains (2) .
- Shorten the chain if more spring tension is required. Lengthen the chain if less spring tension is required.
Caterpillar Information System:
784C, 785B, 785C, 785D, 789B, 789C, 789D, 793B, 793C, 793D, 797 and 797B Off-Highway Trucks VIMS ™ MID 049 - CID 1422 - FMI 12
784C, 785B, 785C, 785D, 789B, 789C, 789D, 793B, 793C, 793D, 797 and 797B Off-Highway Trucks VIMS ™ MID 049 - CID 1421 - FMI 12
784C, 785B, 785C, 785D, 789B, 789C, 789D, 793B, 793C, 793D, 797 and 797B Off-Highway Trucks VIMS ™ MID 049 - CID 1273 - FMI 12
784C, 785B, 785C, 785D, 789B, 789C, 789D, 793B, 793C, 793D, 797 and 797B Off-Highway Trucks VIMS ™ MID 049 - CID 1422 - FMI 09
784C, 785B, 785C, 785D, 789B, 789C, 789D, 793B, 793C, 793D, 797 and 797B Off-Highway Trucks VIMS ™ MID 049 - CID 1421 - FMI 09
784C, 785B, 785C, 785D, 789B, 789C, 789D, 793B, 793C, 793D, 797 and 797B Off-Highway Trucks VIMS ™ MID 049 - CID 1273 - FMI 09
312C, 315C, 318C, 319C, 320C, 321C, 322C, 325C, 330C and M325C Excavators and 325C MHPU and 330C MHPU Mobile Hydraulic Power Units Engine and Pump Control - V2 Switches
784C, 785B, 785C, 785D, 789B, 789C, 789D, 793B, 793C, 793D, 797 and 797B Off-Highway Trucks VIMS ™ MID 049 - CID 1422 - FMI 02
784C, 785B, 785C, 785D, 789B, 789C, 789D, 793B, 793C, 793D, 797 and 797B Off-Highway Trucks VIMS ™ MID 049 - CID 1421 - FMI 02
784C, 785B, 785C, 785D, 789B, 789C, 789D, 793B, 793C, 793D, 797 and 797B Off-Highway Trucks VIMS ™ MID 049 - CID 1273 - FMI 02
776D Wheeled Tractor and 777D and 777D HAA Off-Highway Trucks Power Train Oil Filter and Base (Transmission Charging) - Assemble
776D Wheeled Tractor and 777D and 777D HAA Off-Highway Trucks Power Train Oil Filter and Base (Transmission Charging) - Disassemble
3508B Engine for 854G Wheel Dozers and 992G Wheel Loaders Injector Solenoids
550 Wheel Harvester, 570 Wheel Harvester and 580 Wheel Harvester Power Train Travel Motor
2000/03/06 An Improved Input Pinion Is Now Used {3254, 3256, 3258}
8-16B, 10-20B and 10-20WB Extend-A-Mat<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> Screed Before Paving Setup
784C, 785B, 785C, 785D, 789B, 789C, 789D, 793B, 793C, 793D, 797 and 797B Off-Highway Trucks VIMS ™ Switch Circuits
Installation of the 172-9321 Metering Pump for the Steering System{4312} Installation of the 172-9321 Metering Pump for the Steering System{4312}
725 and 730 Articulated Trucks Oscillating Hitch - Lubricate
2000/05/01 New Axle Housings Increase the Parts' Commonality {3259, 3260, 3278}
824G Wheel Dozer, 825G Soil Compactor and 826G Landfill Compactor Hydraulic System Vane Pump (Implement)
988G Wheel Loader Power Train Differential and Bevel Gear - Install - Rear
2000/03/13 Serviceable Parts of the Fuel Injection Pump {1251, 1251}
725 and 730 Articulated Trucks Hoist, Steering, and Brake System Breather - Inspect/Replace