Installation Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Place measuring arm cylinder (7) in position on the harvester head.
Illustration 1 | g00639833 |
- Install pivot pin (9). Install the nut on pivot pin (9) .
- Install the pivot pin in the tube end of the cylinder tube. Install the nut on the pivot pin.
- Connect two hydraulic hose assemblies (6) and (6) to measuring arm cylinder (7) .
Illustration 2 | g00639832 |
- Raise valve plate (3) into position. Install bolts (4) .
Illustration 3 | g00639835 |
- Install cover (2) on the front of the harvester head. Install cover (1) on the front of the harvester head.
Illustration 4 | g00639862 |
- Lubricate the bearings through the provided fittings. Use 1P-0808 Multipurpose Grease .
- Install the hydraulic valve cover.