If a safety sign is damaged or missing, the safety sign must be replaced. If a safety sign cannot be read, the safety sign must be replaced. If a safety sign is located on a part that has been replaced, a new safety sign must be placed on the new part. Consult your Caterpillar dealer for new safety signs.
 | |
| Illustration 2 | g00665990 |
 |
Do not operate this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact any Caterpillar dealer for replacement manuals. Proper care is your responsibility. |
 |
 | |
| Illustration 3 | g00570977 |
This safety sign is located on the instrument panel.
 | |
| Illustration 4 | g00666024 |
|
No clearance for a man in this area when the machine turns. Severe injury or death from crushing could occur. Install the steering frame lock pin into the locked position before lifting the machine, transporting the machine on another vehicle, or performing service near the center of the machine. Disengage the steering lock pin from articulation joint and store in retainer before resuming operation or the machine will not steer. |
|
 | |
| Illustration 5 | g00560745 |
This safety sign is located on both sides of the yoke.
 | |
| Illustration 6 | g00038786 |
|
Improper jump start cable connections can cause an explosion resulting in personal injury. Batteries may be located in separate compartments. When using jump start cables, always connect the positive (+) to the positive (+) terminal of the battery that is connected to the starter solenoid and the negative (-) cable from the source to the negative (-) terminal of the starter. (If the machine is not equipped with a starter negative terminal, connect the negative (-) cable to the engine block.) Follow the procedure in the Operation and Maintenance Manual. |
|
 | |
| Illustration 7 | g00560790 |
The safety sign is located on the side of the battery box.
 | |
| Illustration 8 | g00100745 |
|
If equipped with an air inlet heater (AIH) for cold weather starting, do not use aerosal types of starting aids such as ether. Such use could result in an explosion and personal injury. |
|
 | |
| Illustration 9 | g00572497 |
This warning is located on the cover of the air filter housing.
 | |
| Illustration 10 | g00102169 |
|
The protection offered by this ROPS will be impaired if the ROPS has been subjected to any modification, structural damage, or has been involved in an overturn accident. This ROPS must be replaced after a roll-over. Seat belts must be worn while operating the vehicle. |
|
 | |
| Illustration 11 | g00560837 |
This safety sign is located on the ROPS.