Tachometer Drive
Usage:
Remove & Install Tachometer Drive
1. Remove bolts (1) and the clamps that hold adapter assembly (2) in position.
2. Remove the adapter assembly and coupling from the governor housing.
3. Remove coupling (3) and O-ring seal (4) from adapter assembly (2).
NOTE: The following steps are for installation of the tachometer drive.
4. Inspect the parts for wear or damage. Make a replacement if necessary.
5. Install O-ring seal (4) and coupling (3) on adapter assembly (2).
6. Install the adapter assembly in the governor housing.
NOTE: Make sure that the coupling engages with the shaft of the governor.
7. Fasten the adapter assembly to the governor housing with bolts (1) and the clamps.
Caterpillar Information System:
3406C DIESEL TRUCK ENGINE Electric Starting Motor
3406C DIESEL TRUCK ENGINE Fuel Injection Line Adapters
3406C DIESEL TRUCK ENGINE Fuel Injection Lines
3406C DIESEL TRUCK ENGINE Air Compressor
3406C DIESEL TRUCK ENGINE General Instructions (D & A)
3406C DIESEL TRUCK ENGINE Engine Vibration Troubleshooting
3406C DIESEL TRUCK ENGINE Fuel In Crankcase Oil
3406C DIESEL TRUCK ENGINE Loss Of Coolant
3406C DIESEL TRUCK ENGINE Cooling System
3406C DIESEL TRUCK ENGINE Engine Does Not Start
3406C DIESEL TRUCK ENGINE Hard Starting (Engine Crankshaft Turns Freely)
3406C DIESEL TRUCK ENGINE Excessive White Or Blue Exhaust Smoke
3406C DIESEL TRUCK ENGINE Fuel Priming Pump
3406C DIESEL TRUCK ENGINE Fuel Filter And Base
3406C DIESEL TRUCK ENGINE Fuel Transfer Pump
3406C DIESEL TRUCK ENGINE Fuel Ratio Control
3406C DIESEL TRUCK ENGINE Automatic Timing Advance
3406C DIESEL TRUCK ENGINE Fuel Injection Pump Housing And Governor
3406C DIESEL TRUCK ENGINE Governor
3406C DIESEL TRUCK ENGINE Fuel Injection Pumps
3406C DIESEL TRUCK ENGINE Fuel Injection Pump Housing
3406C DIESEL TRUCK ENGINE Turbocharger (Earlier)
3406C DIESEL TRUCK ENGINE Turbocharger (Later)
3406C DIESEL TRUCK ENGINE Water Temperature Regulator And Manifold