NOTICE |
---|
Improper lifting or tiedowns can allow load to shift and can cause injury and damage. |
Lifting the Machine
NOTICE |
---|
Improper lifting or tiedowns can allow load to shift and can cause injury and damage. |
Refer to the table in Operation and Maintenance Manual, "Specifications" for specific weight information.
Use properly rated cables and properly rated slings in order to lift the machine.
Position the crane or the lifting device in order to lift the machine in a level position.
Check the appropriate laws that govern the weight of the load. Check the appropriate laws that govern the width of the load and the length of the load.
- Apply the parking brake.
- After the machine has been moved into position, install the steering frame lock pin. The pin will hold the front frame and the rear frame rigid. Remove pin (2). Lower steering frame lock pin (1). Reinstall pin (2) in hole (3) .
Illustration 1 | g00579175 |
- Turn the engine start switch key to the OFF position. Remove the key.
- Refer to sign (1) that is located on the right side of the machine. The sign has information on lifting the machine and tying down the machine.
Illustration 2 | g00686759 |
- Attach the lifting device to the front and to the rear of the machine. Lifting eye (2) is located at each corner of the machine. The lifting eyes are identified by a label that shows a hook.
Illustration 3 | g00686770 |
- Lift the machine slowly in order to make sure that the machine stays level. Move the machine to the desired location.
- When the machine is positioned, place blocks high in the center of the yoke on each side of the machine in the front and in the rear. The blocks are put in place in order to prevent excessive loads on the drum support bearings.
Illustration 4 | g00686787 |
Tying Down the Machine
NOTICE |
---|
Improper lifting or tiedowns can allow load to shift and can cause injury and damage. |
- Secure the machine by using the tie down locations at each corner of the machine.
Illustration 5 | g00686792 |
See your Caterpillar dealer for further information and instructions for your machine.
See the Operation and Maintenance Manual, "Shipping the Machine" for further information.