D250E Series II and D300E Series II Articulated Trucks Caterpillar

Investigate the travel route for overpass clearances. Make sure that there is adequate clearance for the machine that is being transported. This is especially important for machines that are equipped with a ROPS, with a FOPS, with a cab, or with a canopy.

Remove ice, snow, or other slippery material from the loading dock and from the truck bed before you load the machine onto the transport machine. Removing ice, snow, or other slippery material will help to prevent the machine from slipping in transit.

For basic machine specifications, refer to Operation and Maintenance Manual, "Model Views".

Show/hide table

NOTICE
Obey all state and local laws governing the weight, width and length of a load. Remove the starting aid (ether) cylinder, if equipped. Make sure the cooling system has proper antifreeze if moving machine to a colder climate. Observe all regulations governing wide loads.

Show/hide table



Illustration 1	g00614904

1. Before you load the machine, chock the trailer wheels or the rail car wheels, as shown.

Show/hide table



Illustration 2	g00614905

2. Lower the dump body. When you transport a machine without a dump body, suitable retainers must be installed in order to support the hoist cylinders. Consult your Caterpillar dealer for more information.

3. When the machine is positioned on the transport machine, install the steering frame locks.

   Refer to Operation and Maintenance Manual, "Steering Frame Lock".

4. Move the transmission control to the NEUTRAL position.

5. Lower the front suspension. .

   Refer to Operation and Maintenance Manual, "Suspension - Lower".

6. Engage the parking brake.

7. Stop the engine.

8. Turn the engine start switch to the OFF position. Remove the engine start switch key.

9. Turn the battery disconnect switch to the OFF position. Remove the battery disconnect switch key.

10. Lock the cab door. Attach any vandalism protection.

11. Chock the tires. Secure the machine with tie-downs.

    Refer to Operation and Maintenance Manual, "Lifting and Tying Down The Machine".

12. Cover the exhaust opening or secure the rain cap in order to prevent the turbocharger from windmilling in transit.

Perform a walk-around inspection and do fluid level checks.

Travel at a moderate speed. Observe all speed limitations when you are roading the machine.

Consult your Caterpillar dealer for shipping instructions for your machine.