Removal Procedure
Start By:
- Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines. Dispose of all fluids according to local regulations and mandates. |
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
Note: Put identification marks on all lines, on all hoses, on all wires and on all tubes for installation purposes. Plug all lines, all hoses and all tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
- Park the machine on a flat, level surface. Lower the bucket to the ground. Chock the wheels in order to keep the machine from rolling when the parking brake is released.
- Disconnect hydraulic brake hose (1) from parking brake actuator (2) .
Illustration 1 | g00335235 |
- Remove clevis pin (6). Disconnect yoke assembly (5) from parking brake actuator lever (4) .
Illustration 2 | g00335237 |
- Remove nuts (3) and parking brake actuator (2) .
Installation Procedure
- Install parking brake actuator (2) and nuts (3) .
Illustration 3 | g00335237 |
- Connect yoke assembly (5) to parking brake actuator lever (4). Install clevis pin (6) .
- Connect hydraulic brake hose (1) to parking brake actuator (2) .
Illustration 4 | g00335235 |
- Adjust the parking brake actuator. Refer to Testing and Adjusting, SENR1387, "Parking Brake Actuator - Adjust".
End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".