Auger Conveyors - Lubricate - Lubricate the Fittings
Show/hide table
| NOTICE |
|---|
All daily grease lubricant should be applied at the end of each machine operation while the machine is still warm and the asphalt is still soft or not set up. Failure to do so may allow asphalt to harden around the seals and risk damaging a seal and lead to premature bearing failure. |
Note: Add lubricant only until excess oil is observed at each of the bearings.
Show/hide table
 | |
| Illustration 1 | g00569476 |
Lubricate the two fittings for the inside bearings. The fittings are on the chain case at the rear of the machine.
Show/hide table
 | |
| Illustration 2 | g00569477 |
Lubricate the two fittings for the outside bearings. The fittings are on each side at the rear of the machine.
Caterpillar Information System:
CP-563D, CS-563D, CS-573D and CS-583D Vibratory Compactors Propel System Piston Pump (Drum Propel)
AP-1055B and BG-2455C Asphalt Pavers Capacities (Refill)
AP-1055B and BG-2455C Asphalt Pavers Parking Brake Manual Release
AP-1055B and BG-2455C Asphalt Pavers Stopping the Engine if an Electrical Malfunction Occurs
AP-1050B and BG-245C Asphalt Pavers Hydraulic Screed Counterbalance System
AP-1055B and BG-2455C Asphalt Pavers Tow Point Cylinders
950G and 962G Wheel Loaders and IT62G Integrated Toolcarrier Machine Systems Quick Coupler - Remove and Install
AP-1050B and BG-245C Asphalt Pavers Walk-Around Inspection
AP-1055B and BG-2455C Asphalt Pavers Screed Travel Lock
8-16B, 10-20B and 10-20WB Extend-A-Mat<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> Screed Tow Point Control
572R Pipelayer Hydraulic System Shuttle Valve
550, 570 and 580 Wheel Harvesters Tilt Hood
AP-1055B and BG-2455C Asphalt Pavers Conveyor Drive Chains (Drag) - Adjust
572R Pipelayer Hydraulic System Pilot Control Valve (Three-Way)
950G and 962G Wheel Loaders and IT62G Integrated Toolcarrier Machine Systems Pin Coupler Cylinder - Remove and Install
D250E Series II and D300E Series II Articulated Trucks Machine Systems Check and Pressure Reducing Valve (Brake Accumulator) - Remove
CP-563D, CS-563D, CS-573D and CS-583D Vibratory Compactors Propel System Propel Hydraulic System
793C Off-Highway Truck Machine Systems Service and Parking Brake (Rear) - Assemble
980G Wheel Loader Braking System Parking Brake Control Cable
IT14G Integrated Toolcarrier and 914G Wheel Loader Machine Systems Tilt Lever (Rear) - Remove and Install
65E, 75E, 85E and 95E Agricultural Tractors After Starting Engine
950G and 962G Wheel Loaders and IT62G Integrated Toolcarrier Machine Systems Attachment Positioner Control - Remove and Install
DASA 280 Measuring and Control System Control Unit
DASA 280 Measuring and Control System Hand Control Keypads