950G and 962G Wheel Loaders and IT62G Integrated Toolcarrier Power Train Caterpillar

Assembly Procedure

1. Make sure that all parts are thoroughly clean prior to assembly. Apply clean SAE 30 oil to all parts.

Show/hide table



Illustration 1	g00321551

2. Install two locating dowels in oil pump manifold (4). The correct assembled height of the locating dowels is 5 ± 0.5 mm (0.20 ± 0.020 inch).

3. Install O-ring seal (7) .

Show/hide table



Illustration 2	g00844353
Oil Pump Manifold

4. Use Tooling (A) to install two sleeve bearings (8) in oil pump manifold (4). Install the bearings into the bores so that the bearings are 1.5 ± 0.5 mm (.06 ± .02 inch) below the surface. Install the bearings so that the bearing joints are 30 ± 15 degrees from the centerlines of the shafts, as shown.

Show/hide table



Illustration 3	g00321550

5. Install pump gear assembly (6) .

Show/hide table



Illustration 4	g00321549

6. Install pump drive gear assembly (5) in oil pump manifold (4) .

Show/hide table



Illustration 5	g00844353
Oil Pump Manifold

7. Use Tooling (A) to install two sleeve bearings (3) in oil pump cover assembly (2). Install the bearings into the bores so that the bearings are 1.50 ± 0.50 mm (.06 ± .02 inch) below the surface. Install the bearings so that the bearing joints are 30 ± 15 degrees from the centerlines of the shafts, as shown.

Show/hide table



Illustration 6	g00321547

8. Install oil pump cover assembly (2) .

Show/hide table



Illustration 7	g00321546

9. Install six bolts (1) in oil pump cover assembly (2). The torque for bolts (2) is 55 ± 10 N·m (41 ± 7 lb ft).

End By: Install the transmission oil pump. Refer to Disassembly and Assembly, "Transmission Oil Pump - Install".