After Starting Engine
Show/hide table
Illustration 1 | g00104938 |
Show/hide table
NOTICE |
---|
Keep the engine speed low until the engine oil fault alarm shuts off and the indicator light shuts off. Wait for ten seconds. If the indicator light stays on, stop the engine. Investigate the cause of the problem before you start the engine again. |
- Warm up the engine at low idle for five minutes. With the boom in the LOCKED position, cycle the hydraulic cylinders in order to circulate the oil. Move the control for the boom to the BOOM DOWN position for one minute. Release the control for the boom for one minute. Repeat this procedure until the hydraulic system is warm enough to operate the attachments.
- Monitor the gauges while you operate the machine controls.
- The parking brake indicator will remain on until you release the parking brake.
While you idle the engine for warm-up, observe the following recommendations:
- If the temperature is greater than 0° C (32° F), warm up the engine for approximately 15 minutes.
- If the temperature is less than 0° C (32° F), warm up the engine for approximately 30 minutes.
- If the temperature is less than - 18°C (0°F) or if hydraulic functions are sluggish, additional time may be required.
Caterpillar Information System:
446B Backhoe Loader Accelerator Control
793B Off-Highway Truck Power Train Torque Converter and Transmission Pressure Chart
793B Off-Highway Truck Power Train Final Drive
793B Off-Highway Truck Power Train Speed Sensor (Rear Wheel)
IT38F Integrated Toolcarrier and 938F Wheel-Type Loader Secondary Steering System Testing and Adjusting
IT28G Integrated Toolcarrier and 928G Wheel Loader Transmission Case
793B Off-Highway Truck Power Train Rear Axle Housing
793B Off-Highway Truck Power Train Differential
IT38F Integrated Toolcarrier and 938F Wheel-Type Loader Secondary Steering System System Operation
793B Off-Highway Truck Power Train Differential and Bevel Gear
IT38F Integrated Toolcarrier and 938F Wheel-Type Loader Secondary Steering System Specification
IT28G Integrated Toolcarrier and 928G Wheel Loader Output Transfer Gears
416C, 426C, 428C, 436C and 438C Backhoe Loaders Air Conditioner - Test - If Equipped
446B Backhoe Loader Air Conditioner Belt - Inspect/Adjust/Replace
446B Backhoe Loader Alert Indicators
446B Backhoe Loader Alternate Exit
446B Backhoe Loader Alternator and Fan Belts - Inspect/Adjust/Replace
3208 Marine Engine Additional Reference Material
446B Backhoe Loader Axle Oscillation Bearings - Lubricate
446B Backhoe Loader Backhoe Boom, Stick, Bucket, and Cylinder Bearings - Lubricate
446B Backhoe Loader Backhoe Foot Operated Auxiliary Control - If Equipped
446B Backhoe Loader Backhoe Foot Operated Extendible Stick Control
446B Backhoe Loader Backhoe Four Lever Control
IT28G Integrated Toolcarrier and 928G Wheel Loader Torque Converter Inlet Relief Valve