Low Profile Exhaust Pipe Available {1061}
Usage:
PM-565 (3TK1-107) Cold Planers
Due to requests from dealers and customers, a low profile/horizontal exhaust pipe is being made available for the PM-565 Cold Planers. The exhaust pipe may be purchased direct from the supplier and installed as shown in the illustrations. The new pipe is adaptable to the machines listed above.
The low profile exhaust pipe can be ordered by part number HD 8508, Rev A, (less venturi tube) from:
4901 Stickney Ave.
Toledo, Ohio 43612
Phone: 1-800-292-9744
Illustration 1. Position of exhaust pipe. (A) Top view of rear cover. (B) Side view of rear cover. (1) Riker, HD 8508 Exhaust Ejector Assembly.
Illustration 2.
Caterpillar Information System:
1996/05/06 Transmission Oil Change Refill And Start-up Procedure {3004}
1996/05/06 New Body Pivot Pins Now Used {7258}
1996/05/06 Wheel Bearing Adjustment Intervals {4201,4208}
1996/05/06 Improvements To Challenger Agricultual Tractors Air Conditioning Available {7320,7343,7311}
1996/05/06 Steering Pump Pressure Limiter Logic Plugs Can Be Checked For Proper Torque {4306}
1996/05/06 High Performance Grease Used On Brake Control Linkage {4269}
1996/05/06 Service Magazine Special Edition, SEPD0304, Available {0374}
1996/05/06 Cast Duo-Cone Seals Available For Final Drives {4052,7561}
1996/04/29 New Element Assemblies Available Within Jacket Water Heater Groups{1383}
1996/04/29 New Piston Assembly And New Piston Ring Kit Provide Reduced Oil Consumption{1214,1215}
1996/04/29 New Rear Crankshaft Seal Improves Service Life{1161}
1996/04/29 Integral Connector Now Used On The Air Conditioning Condenser Fan Motor Relay Assembly{1408,7320}
1996/05/06 Starter Solenoid Assembly May Need New Terminal {1467,1518}
1996/05/13 Improved Transmission Downshift Switch Available {1435,1400}
1996/05/13 New Stronger Cylinder Head Bolts Used {1100}
1996/05/13 Torque Check Necessary For Front Support Bracket Bolts When Damper And Pulley Are Removed {1153}
1996/05/13 New Components In Engine Camshaft Groups Provide Increased Lubrication To Thrust Washer Assembly {1210}
1996/05/20 New Assembly Procedure For Hoist Pump Groups With Double Shaft Seals And Weep Hole{5073}
1996/05/20 Hydraulic Tank Breather Location Change Affects Tank Filling Procedure{5056}
1996/06/03 Latches May Not Secure Radiator Guard Properly, Without Correct Panel Position{7155}
1996/06/03 Additional Transmission Clutch Piston Return Springs Have Been Added To Improve Service Life In Off-Highway Trucks{3150}
1996/06/03 Field Repair For Cracked Upper Strut Mount Plate{7051}
1996/06/03 Long Life Coolant Antifreeze (LLCA) Used In Cooling System{1395}
1996/06/03 U-Cup Rod Seals Available For Hydraulic Cylinders Used In Cold Temperatures{5102,5104}