Usage:
1. Put 7M7260 Liquid Gasket Material on bottom of housings and surface of contact with cylinder block.
2. Put four 3/8"-16 NC bolts (1) for a guide in the cylinder block.
3. Install a 3/8"-16 NC forged eyebolt in back of housing. Fasten a hoist and put the injection pump housing, shutoff control, governor, and governor drive in position on engine.
4. Lower the unit on the guide bolts (1). Install the bolts that hold unit to cylinder block.
5. Fasten a hoist to water temperature regulator housing, manifold, lifting eye and support (2). Install as a unit. Install the bolts and connect the water lines.
6. Install the fuel line (3) on front of injection pump housing.
7. Install oil line (6) on the governor. Install air line to fuel ratio control.
8. Install the lifting eye and support (4) on back of governor drive housing.
9. Install the bolts (5) that hold exhaust elbow to support.
10. Make adjustment of timing; See TIMING THE FUEL INJECTION PUMP CAMSHAFT in TESTING AND ADJUSTING.
end by:
a) install exhaust manifold
b) install fuel injection lines