Valve Covers
Usage:
Remove Valve Covers
1. Remove bolts (1), and remove valve cover (2) from the valve cover base.
2. If necessary, remove the seal from valve cover (2).
Install Valve Covers
1. Make sure seal (1) is installed in the groove of valve cover (3).
2. Put valve cover (3) in position on valve cover base (2), and install the four bolts to hold it.
Caterpillar Information System:
3512 AND 3516 EUI ENGINES Rear Gear Group
3512 AND 3516 EUI ENGINES Accessory Drive (Rear)
3512 AND 3516 EUI ENGINES Flywheel Housing
3512 AND 3516 EUI ENGINES Front Drive Housing
3512 AND 3516 EUI ENGINES Crankshaft Rear Seal And Wear Sleeve
3512 AND 3516 EUI ENGINES Crankshaft Front Seal And Wear Sleeve
3512 AND 3516 EUI ENGINES Crankshaft Pulley & Vibration Damper
3512 AND 3516 EUI ENGINES Oil & Water Pump Drive
3512 AND 3516 EUI ENGINES Personality Ratings Module
3512 AND 3516 EUI ENGINES Electronic Control Module (ECM)
3512 AND 3516 EUI ENGINES Aftercooler
3512 AND 3516 EUI ENGINES Exhaust Manifolds
3512 AND 3516 EUI ENGINES Unit Injectors
3512 AND 3516 EUI ENGINES Rocker Shaft Assemblies And Push Rods
3512 AND 3516 EUI ENGINES Rocker Shaft Assemblies
3512 AND 3516 EUI ENGINES Cylinder Head Assemblies
3512 AND 3516 EUI ENGINES Valves
3512 AND 3516 EUI ENGINES Valve Lifters
3512 AND 3516 EUI ENGINES Bridge Dowels
3512 AND 3516 EUI ENGINES Valve Seat Inserts
3512 AND 3516 EUI ENGINES Valve Guides
3512 AND 3516 EUI ENGINES Spacer Plates
3512 AND 3516 EUI ENGINES Piston Cooling Jets
3512 AND 3516 EUI ENGINES Camshafts