Tips For Service Information Retrieval System (SIRS) Users
Usage:
SIRS Index-Miscellaneous Items And Special Publications
On the last fiche of the SIRS INDEX for Engines are two sections with no model identification in the heading. Each section has a special purpose.
-
- ... Miscellaneous Items. If you cannot find an article or instruction under a model name, look at the section titled "MISCELLANEOUS ITEMS". If the article you need is general in nature, you will find it at the end of the last fiche in the library. Examples of such articles are announcements of new tools, seals, turbocharger parts and lubrication recommendations.
- ... Special Publications. Some magazines and booklets are printed one time. They are shown on the last fiche in the SIRS Index in a section called "SPECIAL PUBLICATIONS". In this section you will find "Guidelines for Reusable Parts", "Analyzing Failure" booklets and "Successful Engine Service". These booklets are listed one time in Component Code order of the subject matter.
- ... Miscellaneous Items. If you cannot find an article or instruction under a model name, look at the section titled "MISCELLANEOUS ITEMS". If the article you need is general in nature, you will find it at the end of the last fiche in the library. Examples of such articles are announcements of new tools, seals, turbocharger parts and lubrication recommendations.
Caterpillar Information System:
1978/08/30 New Vent Tube For Water Cooled Turbocharger
1978/08/30 Overlap Joint On Crankshaft Front Seal Ring Prevents Leakage
1978/08/30 New Nozzle Assembly Used In Fuel Injection Valves
1978/08/30 List Of Service Publications
1978/08/30 Improved Piston Pins Are Made Of Different Material For Better Hardness Characteristics When Heat Treated
1978/08/30 New Oil Supply Line And Gasket For Turbocharter
1978/08/30 Sleeve-Type Ring Compressors Can Be Used For Installation Of Pistons From The Bottom Of The Engine
1978/08/30 New Camshaft Rear Bearing For The Sleeve Metering Fuel System
1978/08/30 The Causes And Reduction Of White Exhaust Smoke During Cold Engine Starts; Maintenance Aids Available To Decrease This Problem
1978/08/30 Different O-Ring Seals Now Used In Fuel Injection Pump Group
1978/08/30 Change In Procedure To Check Main Bearing Clearance
1978/08/30 New Design Seals Decrease Shaft Wear In Fuel Transfer Pump
1978/08/30 Improved Guide Pin For Fuel Injection Pump Lifters
1978/08/30 New Gasket Used In Exhaust Manifold Group
1978/08/30 New Diaphragm Used In Mechanical Shut-Off Groups Has Identification For Correct Installation
1978/08/30 New Water Pump Gives More Pressure
1978/08/30 New Torque Specification Used On Bolts That Hold The Cylinder Head
1978/08/30 New Drive Adapters For Fuel Injection Test Bench
1978/09/27 Tips For Service Information Retrieval System (SIRS) Users
1978/09/27 New Springs Available For Forward And Reverse Clutches, And New Tool To Correctly Position The Clutches Of Twin Disc MG514 Marine Transmission
1978/09/27 New 5P8744 Adapter Assembly And Special Instruction Procedures For 5P4150 Nozzle Tester Group
1978/09/27 Correct Procedure To Adjust Front Power Takeoff Clutches
1978/09/27 List Of Service Publications
1978/10/18 Correct Installation Of Crankshaft Thrust Plates Is Very Important To Prevent Engine Damage