Use The Drive Sleeve On The Fuel Injection Pump Camshaft Only One Time
Usage:
All 3208, 3304, 3306 Engines Equipped With Sleeve Metering Fuel Systems
When it becomes necessary to remove the fuel transfer pump from the fuel injection pump housing, the 4N2954 Drive Sleeve on the fuel injection pump camshaft must be removed. Any time the drive sleeve is removed from the camshaft, a new drive sleeve must be installed. The camshaft has serrations (splines) that cut grooves into the drive sleeve when it is installed, to give a positive drive. If a formerly used drive sleeve is installed again, it can slip (slide around) on the camshaft.
Installation of drive sleeve.
Caterpillar Information System:
1978/07/05 Stronger Fan Blades Used On 1693 Truck Engines In White Autocar Trucks
1978/07/05 Use New Main Bearings In Replacement Cylinder Blocks
1978/07/05 Clip Added To Compressor Lines Group To Keep Oil Line Away From Exhaust Manifold
1978/07/05 New BrakeSaver Rotor Support Prevents Damage To Seals And Stator
1978/07/05 A New Exhaust Manifold And Fuel Pump Heat Shield Is Used On Industrial Engines That Have A Woodward Governor With An Electric Motor
1978/07/05 Disconnected Air Cleaner Hose Can Cause Engine Damage
1978/07/05 New Color For Fiche In Engine Numerical Parts Record Library
1978/07/05 Mounting For Transmission/Torque Converter Oil Cooler Improved To Decrease Vibration
1978/07/05 Grind Material From Boss On Parts Service Cylinder Block To Give Clearance For Starting Motor Mounting Bolt
1978/07/05 A One-Piece Spring Seat Is Now Used In The Governor
1978/07/05 Do Not Use Plastic Tubing And Compression Fittings Without An Insert As A Fuel Supply Line
1978/07/05 New Vibration Damper Has Stronger Mounting Flange To Prevent Possible Cracks
1978/07/05 Improved Seal Rings For Turbine End Of Turbochargers
1978/07/05 New One-Piece Flywheel Housing Gasket
1978/07/05 Fluid-Type Vibration Damper Now Used Instead Of Rubber-Type Damper
1978/07/05 New Dashpot Spring Gives A Reduction In "Overshoot"
1978/08/16 New Flange-Type Seal Used At Rear Of Crankshaft
1978/08/16 Remove Fuel Injection Nozzles Before The Bottom Surface Of A Cylinder Head Is Cleaned
1978/08/16 Four New Contact Points Added To 5P6524 Engine Timing Indicator Group
1978/08/16 Four New Parts Books For 3406 Truck Engines
1978/08/16 List Of Service Publications
1978/08/16 New Gasket Kits To Service Caterpillar Diesel And Natural Gas Engines
1978/08/16 New Glow Plug Wiring Harness Prevents Short Circuit
1978/08/30 New Design Seals Decrease Shaft Wear In Fuel Transfer Pump