1994/01/01 Caterpillar

Low Coolant Level Plate In Radiator May Cause False Coolant Level Readings{1353}

Usage:

3304 (02B, 04B),
3304B (10E),
3306 (09A, 23C, 66D),
3306B (64Z),
3116 (2WG, 4PG) Industrial Engines

Some 2N-0254 and 2N-0256 Radiator Groups on the above engines may have a low coolant level plate that is "U" shaped. See the illustration. This will allow coolant to stand on the plate. This could result in a false coolant level reading that is higher than the actual level.

Radiator Top Tank (1), Filler Neck (2), Coolant Level Plate (3), (A) Location to drill 3/16inch hole through plate (3).

To prevent this problem, drill a 3/16inch hole through the low coolant level plate. Be sure to remove the chips caused by the drilling operation. This hole will allow the coolant to drain out of the plate when the coolant level is below the plate.

Refer to the appropriate Operation And Maintenance Manual for the correct coolant level.

Caterpillar Information System:

1994/01/01 New Valve Cover Gasket Used{1107}

1993/12/01 Uses, Characteristics, And Removal of Castrol Tarp®, Tarp-B®, And 4164®

1993/12/01 Oil Guidelines For 3600 Engines

1993/12/01 New High Temperature Resistant Seal Group Available For Jacket Water Pump

1993/12/01 Carburetor Control Linkage (EG3P Governor)

1993/12/01 New Inlet/Exhaust Valve Has A Chrome Stem

1993/12/01 New Fuel Injection Lines, Clamps, And Brackets Used In Fuel Injection Lines Groups

1993/12/01 The 1W-1420 Oil Cooler Bracket For Marine Gears Has Been Modified

1993/12/01 Clarify Usage Of Parts Service Cylinder Head Gaskets

1993/12/01 New Fuel Filter Helps Prevent Hard Starting Due To Injector Wear

1993/12/01 New Control Assemblies Used In Fuel Injection Control Groups

1993/11/01 Training Available Via Videotapes For Service And Marketing Systems

1994/01/01 New Piston Body Has Improved Bonding Between Iron Band And Aluminum Body{1214}

1994/01/01 New Diaphragm Used In Governor Air Actuator Group Improves Service Life{1265}

1994/01/01 New 3161 Governors{1289}

1994/01/01 New Torque Specification For The Bolts That Fasten The Rear Housing To The Cylinder Block{1151}

1994/01/01 Proper Storage of Caterpillar Electric Set Generators{1404}

1994/01/01 List of Service Publications

1994/02/01 Fuel Injection Pump Improvements{1251}

1994/02/01 Cylinder Head Gaskets Improved To Provide Better Fire Ring Retention{1124}

1994/02/01 New Turbocharger Groups And New Turbocharger Cartridge Groups Have Improved Thrust Bearing And Turbine Ring Seal{1052,1053}

1994/02/01 Oversize Valve Guides And Valve Seats Available{1103,1104}

1994/02/01 Improved 1R-0716 Oil Filter Should Be Used On 3500 Engines{1318}

1994/02/01 New Spark Plug For Engines{1555}