Camshaft Speed Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove cable straps (2).
- Disconnect harness assembly (1).
Show/hide table
Illustration 2 g06367632 - Remove camshaft speed sensor (3).
Show/hide table
Illustration 3 g06367656 - Remove O-ring seal (4).
Show/hide table
Illustration 1 | g06367625 |
- Install new O-ring seal (4).
Show/hide table
Illustration 5 g06367632 - Install camshaft speed sensor (3). Tighten camshaft speed sensor (3) to a torque of
40 ± 5 N·m (30 ± 4 lb ft) .Show/hide tableIllustration 6 g06367625 - Connect harness assembly (1).
- Install cable straps (2).
Show/hide table
Illustration 4 | g06367656 |
Caterpillar Information System:
C175 Petroleum Engine Aftertreatment SCR System - Decommission
C175 Petroleum Engine Valve Lash - Adjust - Hydraulic Lash Adjusters
C175 Petroleum Engine Fuel Rail Pressure - Release
C175 Petroleum Engine Fuel System Inspection
C175 Petroleum Engine Cooling System Operation
C175 Petroleum Engine Valve Mechanism - Hydraulic Lash Adjusters
3512C and 3512E Engines Engine Idle Reduction System Sensor Supply - Test
G3500H 60Hz Generator Sets Engine Oil Level - Check
C175-16 Petroleum Engines Fuel Pump (High Pressure) - Remove and Install
C175 Petroleum Engine Fuel System Operation
C175-16 Petroleum Engines Fuel Priming Pump - Remove and Install
307.5, 308, 308.5, 309, and 310 Mini Hydraulic Excavator Machine Systems System Pressure - Release
G3500H 60Hz Generator Sets Coolant Sample (Level 1) - Obtain
G3500H 60Hz Generator Sets Engine Oil Sample - Obtain
C32 Generator Set Engines Engine Crankshaft Vibration Damper Counter - Reset
G3512 Generator Set Engine Crankshaft Speed Sensor - Remove and Install
Rework Procedure for Exhaust Rain Cap and Insulation on Certain XQ200 Generator Sets {1072} Rework Procedure for Exhaust Rain Cap and Insulation on Certain XQ200 Generator Sets {1072}
Installation of New Shift Lever Assembly for All Starter Motors {1453} Installation of New Shift Lever Assembly for All Starter Motors {1453}
Procedure to Install the Insulator on to Series Starters on All Engines {1453} Procedure to Install the Insulator on to Series Starters on All Engines {1453}
Installation of Repair Kit-Solenoid Plunger Assembly on All Engines {1453} Installation of Repair Kit-Solenoid Plunger Assembly on All Engines {1453}
Procedure to Install Terminal Kit on All Engines {1453} Procedure to Install Terminal Kit on All Engines {1453}
Procedure to Install Brush Holder Assembly in All Engines {1453} Procedure to Install Brush Holder Assembly in All Engines {1453}
Procedure for Replacing Regulator Kit on All Engines {1405} Procedure for Replacing Regulator Kit on All Engines {1405}
Procedure to Install Brush Holder Assembly to End Frame on All Engines {1405} Procedure to Install Brush Holder Assembly to End Frame on All Engines {1405}