Vibration Damper
Show/hide table
Illustration 1 | g06309866 |
Show/hide table
Item | Qty | Part | Specification Description |
---|---|---|---|
1 | 1 | 428-7539 Damper Gp | The alignment mark on the crankshaft must be aligned with the mark on the adapter. The mark on the damper group must be aligned with the mark on the adapter. |
2 | 48 | - | Use the following procedure to tighten the bolts:
1. Before assembly, apply Precote® 30 to threads and Loctite® 275 to washers. 2. Tighten the bolts to 3. Turn the bolts to an additional angle of 95 + 15 degrees. |
Caterpillar Information System:
320D3 and 323D3 Excavators Systems Relief Valve (Pilot)
320D3 and 323D3 Excavators Systems Hydraulic Filter (Pilot)
320D3 and 323D3 Excavators Systems Gear Pump (Pilot)
797F Tier 4 Off-Highway Truck Engine Supplement Air Starting Motor - Remove and Install
C3.3 Generator Set Insulation - Test
C175 Tier 4 Final Engines for Caterpillar Built Machines Fuel Pump (High Pressure) - Remove and Install
C3.3 Generator Set Model View Illustrations
G3512 Gas Engine Electric Starting Motor
320D3 Hydraulic Excavator Machine Systems Accumulator - Remove and Install
320D3 and 323D3 Excavators Systems Electronic Control Module
C9.3B Engines Inlet Manifold Air Pressure Sensor
323D3 Hydraulic Excavators Engine Supplements Water Temperature Regulator - Remove and Install
320D3 and 323D3 Excavators Systems Oil Filter (Return) - Case Drain Filter
320D3 Excavators Power Receptacle - If Equipped
Installation Procedure of Right Side Camera on Certain 320 and 323 Next Generation Excavators {7348} Installation Procedure of Right Side Camera on Certain 320 and 323 Next Generation Excavators {7348}
320D3 Hydraulic Excavator Machine Systems Recoil Spring - Disassemble
320D3 Hydraulic Excavator Machine Systems Recoil Spring - Assemble
320D3 Hydraulic Excavator Machine Systems Load Control Valve (Stick Cylinder) - Disassemble
320D3 Excavators Fuses - Replace
320D3 Excavators Air Conditioning and Heating Control
320D3 Excavators Joystick Controls
336 Excavator Machine Systems Swing Drive - Remove and Install
Bench Test Procedure for Hydraulic Piston Pumps {5070} Bench Test Procedure for Hydraulic Piston Pumps {5070}
C32 Marine Engine Refill Capacities