Engine Oil Cooler - Assemble
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Thoroughly clean the tubes in the engine oil cooler core.
- Lubricate all seals with the fluids being sealed.
Show/hide table
Illustration 1 g06270452 - Install bonnet (9) and bolts (11) .
- Install bonnet (10) and bolts (12) .
Show/hide table
Illustration 2 g06270450 - Install tube assembly (6). Install bolts (7) and bolts (8).
Show/hide table
Illustration 3 g06270447 Show/hide tablePersonal injury can result from parts and/or covers under spring pressure.
Spring force will be released when covers are removed.
Be prepared to hold spring loaded covers as the bolts are loosened.
- Install spring (2) and bypass valve (1).
- Install bolts (5), plate (4), and O-ring seal (3).
Caterpillar Information System:
C18 Generator Sets Generator Start-up Checklist
G3512H and G3516H Generator Set Engines Engine Oil Cooler - Disassemble
C18 Generator Sets Parallel Operation
C9.3B Engine Fuel Temperature Is High
C9.3B Engine Intake Manifold Air Temperature Is Low
336 Excavators (Powered by C9.3 Tier 4 Engine) Engine Supplement Water Pump - Remove and Install
C7.1 Marine Propulsion Engine Gear Group (Front) - Remove and Install
M0090131 Battery Analyzer 480-4181 (484-4859 Group) {0374, 0599, 0709, 1401, 7468} M0090131 Battery Analyzer 480-4181 (484-4859 Group) {0374, 0599, 0709, 1401, 7468}
G3512H and G3516H Generator Set Engines Engine Oil Cooler - Remove and Install
C9.3B Aftertreatment Systems SCR Inducement Emergency Override
C9.3B Aftertreatment Systems SCR Catalyst Sulfation Is Excessive
C7.1 Industrial Engine Engine Air Cleaner Element - Replace
New Engine Operation Practice is Now Available to Prevent a Shutdown from a 102-0 Code {1000, 1021, 7432} New Engine Operation Practice is Now Available to Prevent a Shutdown from a 102-0 Code {1000, 1021, 7432}
G3500H Generator Set Engine Air Inlet and Exhaust System
C4.4 Industrial Engine Selective Catalytic Reduction Warning System
C7.1 Commercial Marine Engine Customer Specified Parameters
C7.1 Marine Propulsion Engine Camshaft Gear - Remove and Install
C7.1 Marine Propulsion Engine Idler Gear - Remove and Install
New EMCP 4.3 and EMCP 4.4 Software Is Now Used for Certain Cat® Generator Set Engines {1920, 7620} New EMCP 4.3 and EMCP 4.4 Software Is Now Used for Certain Cat® Generator Set Engines {1920, 7620}
C7.1 Commercial Marine Engine Customer Specified Parameters Table
C32 Marine Engine Plate Locations and Film Locations
C7.1 Commercial Marine Engine Electrical Power Supply - Test
C32 Marine Engine Product Description
C7.1 Commercial Marine Engine Fuel Transfer Pump - Test