Electrical Connectors
Connectors for the Electronic Control Module (ECM)
Show/hide table
Illustration 1 | g06211137 |
Locations of the components at the Aftertreatment ECM (1) P2 ECM connector (ECM side) (2) P1 ECM connector (ECM side) (3) P2 ECM connector (harness side) (4) P1 ECM connector (harness side) (5) Aftertreatment ECM |
Show/hide table
Illustration 2 | g06194316 |
Locations of the components at the Dosing Control Unit (DCU) (6) 86-pin Connector (7) 53-pin Connector (8) Dosing Control Unit (DCU) |
Analog Sensor Connector (active)
Show/hide table
Illustration 3 | g01240891 |
Analog Sensor Connector (passive)
Show/hide table
Illustration 4 | g01241538 |
Connectors for the Termination Resistor
Show/hide table
Illustration 5 | g01355248 |
Show/hide table
Illustration 6 | g02219254 |
Refer to Special Instruction, REHS2556 for additional information |
Show/hide table
Illustration 7 | g02220494 |
Refer to Tool Operating Manual, SEHS9615, "Servicing Deutsch HD and DT Style Connectors" for additional information |
Caterpillar Information System:
Selective Catalytic Reduction Retrofit Aftertreatment - Airless Dosing Diagnostic Capabilities
Marine Selective Catalytic Reduction (SCR) Retrofit Aftertreatment Warranty Information
Selective Catalytic Reduction Retrofit Aftertreatment - Airless Dosing Component Location
C175 Tier 4 Final Engines for Caterpillar Built Machines Engine Oil Pump - Remove
Selective Catalytic Reduction Retrofit Aftertreatment - Airless Dosing Electronic Service Tools
Selective Catalytic Reduction Retrofit Aftertreatment - Airless Dosing Welding Precaution
3516B Generator Set Engines with Dynamic Gas Blending Centrifugal Oil Filters
Selective Catalytic Reduction Retrofit Aftertreatment - Airless Dosing General Information
Marine Selective Catalytic Reduction (SCR) Retrofit Aftertreatment Catalyst (SCR) - Replace
C8.7 and C12.9 Marine Engines Speed/Timing - Test
3516B Generator Set Engines with Dynamic Gas Blending Electronic Control Module (ECM) - In Cylinder Pressure Sensor (ICPS) ECM
3516B Generator Set Engines with Dynamic Gas Blending CAN Data Link
Selective Catalytic Reduction Retrofit Aftertreatment - Airless Dosing Configuration Parameters
Selective Catalytic Reduction Retrofit Aftertreatment - Airless Dosing Diagnostic Trouble Codes
Selective Catalytic Reduction Retrofit Aftertreatment - Airless Dosing DEF Control Module Temperature Is High
Selective Catalytic Reduction Retrofit Aftertreatment - Airless Dosing DEF Module Does Not Respond
Selective Catalytic Reduction Retrofit Aftertreatment - Airless Dosing DEF Tank Level Is Low
Selective Catalytic Reduction Retrofit Aftertreatment - Airless Dosing Data Link - Test
C8.7 and C12.9 Marine Engines Sensor Supply - Test
323F SA and 323F LN Excavator Declaration of Conformity
C280 Marine Engines Valve Mechanism
C280 Marine Engines Fuel Injector Mechanism
Valve Mechanism Cover Seal on Certain C7.1 Engines {1107} Valve Mechanism Cover Seal on Certain C7.1 Engines {1107}
Valve Mechanism Cover Seal on Certain C7.1 Machine Engines {1107} Valve Mechanism Cover Seal on Certain C7.1 Machine Engines {1107}