| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 6V-4077 | Camshaft Bearing Tool | 1 |
| 125-2739 (1) | Bearing Pilot | 1 | |
| 125-2740 (1) | Back Up Plate | 1 | |
| 125-2741 (1) | Bearing Sleeve | 1 | |
| B | 8S-2241 | Camshaft Bearing Tool Group | 1 |
| C | 5P-5247 | Hydraulic Puller(2) | 1 |
| D | 8H-0684 | Ratchet Wrench | 1 |
| (1) | Alternate Tooling for camshaft bearings with a large diameter |
| (2) | Do not exceed |
Start By:
- Remove camshafts.
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Use the following steps to install Tooling (A).
- Install the pilot group in camshaft bearing (1) (not shown).
- Place the backup plate in position and ensure that camshaft bearing (1) (not shown) is between the two parts.
- Install the bolt that holds Tooling (A) together.
- Use the extensions to obtain the correct length for Tooling (A).
- Install the puller plate on the bolt and the flywheel housing or the front housing.
Note: Tooling (B) can be used to remove the camshaft bearings when the flywheel housing and the front housing have been removed.
Show/hide table
Illustration 2 g01208875 - Install Tooling (C) on Tooling (A). Pull camshaft bearing (1) from the cylinder block.
Note: Tooling (D) can be used in place of Tooling (C), if necessary.
| |
| Illustration 1 | g01208871 |
- Install camshaft bearing (1) on Tooling (A).
Note: Tooling (B) can be used to install the camshaft bearings when the flywheel housing and the front housing have been removed.
Show/hide table
Illustration 4 g02108639 Rear View
(X) Location of camshaft bearing joints
(Y) Location of oil holes - Position camshaft bearing (1) and Tooling (A) in the bore.
Note: The camshaft bearing joint must be on the horizontal centerline of the bore. The upper oil hole must be 20 ± 5 degrees above the horizontal centerline of the bore. The lower oil hole of the camshaft bearing must be 20 ± 5 degrees below the horizontal centerline of the bore. The camshaft bearing joints must face the inside of cylinder block.
Show/hide table
Illustration 5 g00578349 - Install Tooling (C) on Tooling (A) and pull the camshaft bearing into the bore.
Note: Tooling (D) can be used in place of Tooling (C).
- After the camshaft bearing is installed, measure the bore. The bore must be
92.00 ± 0.06 mm (3.620 ± 0.002 inch) .
| |
| Illustration 3 | g00578338 |
