Leads - Connect
Generator Leads To Terminal Strips
Show/hide table
Illustration 1 | g00613767 |
Terminal Strips |
Show/hide table
Illustration 2 | g00614345 |
Terminal Strip Lead Connections (1) Generator leads (2) Terminal strip (Bus Bar) (3) Plated washer |
Attach the generator leads (1) to terminal strip (2) in the following manner:
- When more than one lead attaches to the bus bar, place the leads on each side of the bus bar. Use flat plated washer (3) under the bolt head and under the nut.
- After connecting the leads to the bus bar, group all generator phase leads together. Tie these leads together.
Ensure that there is a minimum clearance of
Show/hide table
Illustration 3 | g00614361 |
Lead To Lead Connection (Generators with medium voltage or less) (1) Plated washer |
Show/hide table
TOOLS NEEDED | ||
Part Number | Tool | Quantity |
5N-4685 | Varnished cambric electric tape
15000 V rating |
1 |
5N-4686 | Black vinyl plastic electrical tape
|
1 |
When connecting the generator leads together or when connecting generator leads to a load lead, use the following procedure:
- Fasten the generator leads together by using flat plated washer (1) under the bolt head and under the nut.
- Apply two layers of varnished cambric high voltage tape. When the tape is being wrapped, the tape must be overlapped. The tape must be overlapped 50 percent of the width of the tape. Taping must extend length "B" onto the lead wire insulation. Length "B" is equal to
25 mm (1.0 inch) . - Apply two layers of vinyl plastic electrical tape over the varnished cambric high voltage tape. Taping must extend length "A" onto the lead wire insulation. Length "A" is equal to
51 mm (2.0 inch) . - The generator leads must not contact the sheet metal of the terminal box or any rotating parts. For each generator phase, group the leads together. Secure the leads together with cable straps.
Caterpillar Information System:
SRMP Electric Power Generation SRMP Generator Generator - Dry
SRMP Electric Power Generation SRMP Generator Resistor - Test
SRMP Electric Power Generation SRMP Generator Insulation - Test
SRMP Electric Power Generation SRMP Generator Winding - Test
SRMP Electric Power Generation SRMP Generator Rotating Rectifier - Test
SRMP Electric Power Generation SRMP Generator Varistor - Test
SRMP Electric Power Generation SRMP Generator Generator Set - Test
SRMP Electric Power Generation SRMP Generator Troubleshooting
SRMP Electric Power Generation SRMP Generator Service Tools
SRMP Electric Power Generation SRMP Generator General Information
SRMP Electric Power Generation SRMP Generator Glossary
3516C Industrial Engine Product Description
SRMP Electric Power Generation SRMP Generator Exciter Field - Flash
SRMP Electric Power Generation SRMP Generator Generator - Remove
SRMP Electric Power Generation SRMP Generator Generator - Install
SRMP Electric Power Generation SRMP Generator Generator - Align
SRMP Electric Power Generation SRMP Generator Lead Connections
525D, 535D, 545D and 555D Wheel Skidders General Information
3516E Generator Set Model View Illustrations
3516E Generator Set Product Description
C15 and C18 Engines for Caterpillar Built Machines Engine Oil Pan - Remove and Install
463-3475 Well Stimulation Pump Crankshaft Lifting Device{0374, 0599, 0632, 0700, 1202} 463-3475 Well Stimulation Pump Crankshaft Lifting Device{0374, 0599, 0632, 0700, 1202}
2015/07/10 An Improved Alternator Mounting Group Is Now Used On Certain C15 And C18 Engines {1405}
HPU300 Hydraulic Power Pack Lifting and Tying Down