Exhaust System Contains Oil
- 过长怠速时间
- 涡轮增压器密封件损坏
- 气门导管密封件磨损或损坏
- 气门导管磨损
- 活塞环磨损
按所列步骤顺序完成以上步骤。
Show/hide table
| 故障诊断与排除测试步骤 | 数值 | 结果 |
|---|---|---|
1. 过长怠速时间 A. 过长怠速时间会使机油进入排气系统中。 |
怠速时间 |
结果 怠速时间过长。 修理：减少怠速时间。 结果：怠速时间没有过长。 转至测试步骤 2。 |
2. 涡轮增压器密封件损坏 A. 检查进气歧管和排气歧管中有无机油。 |
涡轮密封件 |
结果：进气或排气歧管中有机油。 修理：更换涡轮增压器。 确认修理。 结果：进气或排气歧管中没有机油。 转至测试步骤 3。 |
3. 气门导管密封件磨损或损坏 A. 检查气门导管密封件有无磨损或损坏。 |
气门导管密封件 |
结果：气门导管密封件损坏。 修理：更换气门导管密封件。 确认修理。 结果：气门导管密封件未损坏。 继续测试步骤 4。 |
4. 气门导管磨损 A. 检查气门导管有无磨损。 关于气门导管的最大允许磨损量，请参阅技术规格手册。 |
气门导管 |
结果：气门导管磨损。 修理：必要时，修复缸盖。 确认修理。 结果：气门导管未磨损。 继续测试步骤 5。 |
5. 活塞环磨损 A. 拆下活塞。 请参阅拆解和组装, "活塞和连杆 - 拆卸"。 B. 从活塞上拆下活塞环。 请参阅拆解和装配, "活塞和连杆 - 拆解"。 C. 检查活塞和活塞环有无磨损或损坏。 更多相关资料，请参阅"技术规格"手册。 |
活塞环 |
结果 活塞环磨损。 修理：更换活塞环。 确认修理。 结果 活塞环未磨损。 请联系代理商解决方案网络 (DSN)。 |
Caterpillar Information System:
C4.4 and C7.1 Engines Exhaust System Contains Coolant
C4.4 and C7.1 Engines Exhaust Has Excessive White Smoke
349F and 352F Excavators Machine System Specifications Hydraulic Tank and Filter
G3304B and G3306B Engines Maintenance Interval Schedule - Naturally Aspirated
2015/05/29 A New Piston Is Used on Certain XQC1200 and XQC1600 Power Modules {1225}
3512C Generator Set Engine Fuel Cooler - Remove and Install
C280-08 Tier 4 Engine Water Pump - Remove and Install
3512C Generator Set Engine Fuel Transfer Pump - Assemble
C4.4 and C7.1 Engines Engine Vibration Is Excessive
C4.4 and C7.1 Engines Engine Top Speed Is Not Obtained
C2.2 Engines For Caterpillar Built Machines Solenoid Valve - Test
C4.4 and C7.1 Engines Engine Stalls at Low RPM
3512C Generator Set Engine Turbocharger - Remove and Install
2015/06/05 A New Plug and Washer Are Used on the Oil Pan Group of C8.7 Marine Engines {1325}
797F Off-Highway Truck Field Assembly Hoist Cylinder - Install
C280-08 Tier 4 Engine Auxiliary Water Pump - Remove and Install
C280-08 Tier 4 Engine Prelubrication Oil Pump - Assemble
797F Off-Highway Truck Field Assembly Automatic Lubrication - Install - Service Center
C280-08 Tier 4 Engine Water Pump Seal - Install
2015/06/04 Cat® Reman Is Announcing an Appearance Change to the EI550 Classic, Bridge, and ACERT Electronic Unit Injectors for Certain Machine Engines {1290}
2015/06/05 Cat Reman Is Announcing an Appearance Change to the EI550 Classic, Bridge, and ACERT Electronic Unit Injectors for Certain Commercial Engines {1290}
2015/06/26 Cat® Reman Is Announcing an Appearance Change to the EI550 Classic, Bridge, and ACERT Electronic Unit Injectors for Certain Truck Engines {1290}
2015/05/29 Cat® Reman Announces the Availability of Remanufactured Fuel Check Valves Assemblies for G3600 Engines {1106}
C280-08 Tier 4 Engine Water Pump Seal - Remove