Engine Shutdown While Idling
Use this procedure if one of the following event codes is active. Refer to Troubleshooting, "Event Codes" for information about event codes.
Note: Some of the following codes may not be applicable for certain applications.
Show/hide table
Diagnostic Trouble Codes | ||
---|---|---|
J1939 Code | Description | Comments |
594-0 | Engine Idle Shutdown Driver Alert Mode | The engine is shutting down.
The code is logged. |
593-31 | Engine Idle Shutdown has Shutdown Engine | The engine has been idling for an extended amount of time.
This notification is for the operator. This notification is not a suspected engine problem. The code is logged. |
594-31 | Engine Idle Shutdown Driver Alert Mode | The engine is preparing to shut down because of an extended non-working idle time.
An alarm is activated. The code is logged. |
- Extended idle time
Show/hide table
Troubleshooting Test Steps | Values | Results |
---|---|---|
1. Engine At Idle Speed A. This condition is normal operation. The engine has been idling for an extended amount of time and the Electronic Control Module (ECM) will shut down the engine. B. The "Engine Idle Shutdown Enable Status" parameter in Caterpillar Electronic Technician (ET) can be disabled. The amount of time before engine shutdown can then be configured. |
Normal operation |
Result: This condition is normal operation. Return the unit to service. |
Complete the procedure in the order in which the steps are listed.
Caterpillar Information System:
C13 Industrial Engine Engine Overspeeds
C13 Industrial Engine Engine Overcrank Occurrence
C13 Industrial Engine Engine Misfires, Runs Rough or Is Unstable
C13 Industrial Engine Engine Has Early Wear
C13 Industrial Engine Engine Does Not Crank
G3520H Generator Set Engine Transfer Gearbox - Install
C175-16 Locomotive Engine Clean Emissions Module Has High Oxygen Level
3512E Tier 4 Final Engines for Land Electric Drilling Electrical Power Supply - Test
C13 Industrial Engine Engine Has Mechanical Noise (Knock)
C13 Industrial Engine Engine Cranks but Does Not Start
G3520H Generator Set Engine Transfer Gearbox - Remove
2014/10/31 New Water Lines Are Used On Certain C32 Marine Engines {1052, 1380}
C280 Marine Engines Exhaust Differential Temperature Is High
G3520H Generator Set Engine Gear Group (Rear) - Remove and Install
C13 Industrial Engine Engine Stalls at Low RPM
794 AC Off-Highway Truck Engine Supplement Turbocharger - Remove and Install
C13 Industrial Engine Engine Top Speed Is Not Obtained
C13 Industrial Engine Engine Vibration Is Excessive
C13 Industrial Engine Exhaust Has Excessive Black Smoke
Cat® Command For Hauling Turn Signal, Horn, Low Beam Headlight Do Not Activate in Autonomous Mode
G3520H Generator Set Engine Vibration Damper - Remove and Install
2014/12/05 New Stainless Steel Valve Group (Spray Head) and Software Improvements Are Available for Certain Water Delivery Systems (WDS) on Certain 777F, 777G, and 785D, Off-Highway Truck/Tractors {1408, 5612, 7490, 7610, 7620}
New Software for CX35-P800 Petroleum Transmissions in Select Well Service – Nitrogen Pumper Applications{7620} New Software for CX35-P800 Petroleum Transmissions in Select Well Service – Nitrogen Pumper Applications{7620}
G3500H 50Hz Generator Sets Voltage Regulators