C280 Marine Engines Caterpillar


NOx Conversion Is Low

Usage:

C280-08 J4R
利用本程序对 NOx 低转换效率进行故障诊断与排除。 此外,如果以下任一事件代码为激活或记录状态,应使用本步骤。

表 1
J1939 代码和描述  CDL 代码和描述  注释 
3516-16
后处理 #1 DEF 浓度:高 - 最低严重程度 (1) 
E1365 (2)
后处理 #1 DEF 浓度高 
柴油机排气处理液(DEF)浓度高。 
3516-18
后处理 #1 DEF 浓度:低 - 最低严重程度(1) 
E1364 (2)
后处理 #1 DEF 浓度低 
DEF 浓度低。 
4364-17
后处理 #1 SCR 催化剂转换效率:低 - 最低严重程度(1) 
E1309 (1)
后处理 #1 SCR 催化剂转换效率低 
选择性催化还原 (SCR) 催化剂的 NOx 转换效率低于预期。 
4364-18
后处理 #1 SCR 催化剂转换效率:低 - 中等严重程度(2) 
E1309 (2)
后处理 #1 SCR 催化剂转换效率低 
经过 SCR 催化剂的 NOx 转换效率低于预期。 

表 2
所需工具  数量 
464-1955  工具箱组件 

可能原因

  • 代码

  • DEF 质量

  • DEF 泵

  • DEF 压力管

  • 尿素沉积物

  • 传感器

建议的措施

表 3
故障诊断与排除测试步骤  数值  结果 

1. 检查代码

A. 连接 Cat® 电子技师 (ET) 与维修工具接头。

B。 查找与事件代码系统相关的现行代码。
 

代码
 

结果:相关代码为现行状态。

修理:在继续进行此测试前,诊断并排除所有相关代码。

结果:代码激活或被记录。

转至测试步骤 2。
 

2. 检查 DEF 质量

A. 使用 431-7087 工具总成 (DEF 折射计)或 360-0774 折射计 (Brix) 测量 DEF 质量。 有关更多信息,请参阅测试和调整, "柴油机排气处理液质量 - 测试"。

431-7087 工具总成 (DEF 折射计)无法测量高于 40% 的 DEF 浓度。 该 360-0774 折射计 (Brix) 将读取高达 53% 的 Brix,当在船用应用上测量 DEF 浓度时,必须加以使用。
 

26% 到 51% 的 DEF(25% 到 49% 的 Brix)
 

结果:DEF 质量在可接受的范围内。

转至测试步骤 3。

结果:DEF 质量不在可接受的范围内。

修理:将 DEF 液从储罐中排出。 向罐中加注浓度为 26% 到 51% 的 DEF(25% 到 49% 的 Brix)。

转至测试步骤 3。
 

3. 检查 DEF 泵

A. 将喷射机柜前面的 AC 断路器转至关闭位置。 将配电箱上的 DC 断路器转至关闭位置。

B。 拆下从喷射控制机柜一直到 DEF 喷射器的 DEF 管路。

C. 安装 464-1955 工具箱组件中包含的 DEF 管路附件。

D. 将 DEF 管路伸入 464-1955 工具箱组件包含的容器中。

E. 喷射机柜前面的 AC 断路器转至接通位置。 将配电箱上的 DC 断路器转至接通位置。

F. 连接 Cat ET。

G. 使用 CAT ET 执行以下测试:

- "DEF 喷射系统精度测试"

注:执行此测试时,测试软管可额外包含多达 140 mL (4.76 oz) 的液体。 如果此液体排放到测试容器中,DEF 总量将为 2145 ± 200 mL。
 

2 L ± 200 mL
 

结果:测试收回 2 L ± 200 mL 的 DEF。

继续测试步骤 4。

结果:测试没有收回 2 L ± 200 mL 的 DEF。

修理:更换 DEF 泵。

转至测试步骤 6。 

4.检查排气有无尿素沉积物

A. 将配电箱上的 DC 断路器转至关闭位置至少 1 分钟。

B。 将 DEF 喷射器从排气上拆下。

C. 检查排气有无尿素沉积物挡住 DEF 喷射器、混合器和 SCR 催化器的迹象。

注:排气中存在尿素沉积物属于正常现象,仅当沉积物堵塞来自喷射器的 DEF 流量,或堵塞混合器或 SCR 催化器中的排气流时,才应清除。
 

尿素沉积物
 

结果:有尿素沉积物挡住排气或 DEF 流。

修理:清除排气系统的尿素沉积物。

转至测试步骤 6。

结果:没有尿素沉积物挡住排气或 DEF 流。

继续测试步骤 5。
 

5. 更换 NOx 传感器

A. 将配电箱上的 DC 断路器转至关闭位置。

B。 更换 NOx 传感器。
 

传感器
 

修理:更换 NOx 传感器。

转至测试步骤 6。
 

6. 运转发动机。

A. 喷射机柜前面的 AC 断路器转至接通位置。 将配电箱上的 DC 断路器转至接通位置。

B。 起动发动机。

C. 连接到 Cat 电子技师。

D. 使用 Cat ET 监控下列温度:

- "后处理 #1 SCR 进口温度"

E. 在"后处理 #1 SCR 进口温度"高于 250° C (482° F) 的情况下运转发动机至少 30 分钟。
 

代码
 

结果:代码未激活。

返回工作。
 

如果以上步骤未解决问题,请联系当地 Cat 代理商的技术通信员(TC)。 如需进一步的帮助,您的 TC 可以通过代理商解决方案网络(DSN)与您交谈。

Caterpillar Information System:

2014/10/17 A New Pressure Regulating Valve Is Used on Certain C18 and C32 Marine Engines Equipped with Air Starters {5503}
G3520H Generator Set Engine Flywheel Housing - Remove and Install
Installation of the New Diesel Exhaust Fluid Filter On Certain Tier 4 Final Applications {108K} Installation of the New Diesel Exhaust Fluid Filter On Certain Tier 4 Final Applications {108K}
C3.4B Engines for Caterpillar Built Machines Flexible Exhaust Pipe - Selective Catalyst Reduction (SCR) Mixer Outlet to Inlet of Selective Catalyst Reduction (SCR) Canister
C3.4B Engines for Caterpillar Built Machines Temperature Sensor (Exhaust) - Selective Catalytic Reduction (SCR) Outlet Temperature Sensor
C3.4B Engines for Caterpillar Built Machines Temperature Sensor (Exhaust) - Selective Catalytic Reduction (SCR) Inlet Temperature Sensor
C3.4B Engines for Caterpillar Built Machines Ammonia Sensor
C3.4B Engines for Caterpillar Built Machines Injector (Diesel Exhaust Fluid)
C3.4B Engines for Caterpillar Built Machines Diesel Exhaust Fluid Pump
G3520H Generator Set Engine Engine Oil Filter Housing - Remove and Install
Installation of ECOS Active Bypass Upgrade Kits for Certain G3520C Engines{1917, 1924, 4467} Installation of ECOS Active Bypass Upgrade Kits for Certain G3520C Engines{1917, 1924, 4467}
C280 Marine Engines DEF Tank Temperature Is Low
PMG3516 Power Module Maintenance Interval Schedule - Standby
G3500H 60Hz Generator Sets Engine Oil Filter Differential Pressure - Check
PMG3516 Power Module Maintenance Interval Schedule - Prime Power
2014/10/31 Coolant System Venting Recommendations For Certain G3600 Engines {1350, 1380}
2014/10/23 New Delivery Method for Engine Monitoring System III Software Is Used On Certain 3512C Petroleum Engines {1901, 1920}
2014/10/31 New Engine Software Is Used on Certain C32 Engines {1902, 1920}
2014/10/31 New Water Lines Are Used On Certain C32 Marine Engines {1052, 1380}
G3520H Generator Set Engine Transfer Gearbox - Remove
C13 Industrial Engine Engine Cranks but Does Not Start
C13 Industrial Engine Engine Has Mechanical Noise (Knock)
3512E Tier 4 Final Engines for Land Electric Drilling Electrical Power Supply - Test
C175-16 Locomotive Engine Clean Emissions Module Has High Oxygen Level
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.