C175-16 Petroleum Generator Set Engines Caterpillar


Maintenance Interval Schedule - MCR and Prime

Usage:

C175-16 P5P
在进行任何操作或维护步骤之前,确保已阅读并理解所有的安全信息、警告和说明。 用户负责执行维护,包括所有的调整,使用适当的润滑剂、油液和滤清器。 用户还负责由于正常磨损和老化而更换部件。 未能遵照正确的保养周期和步骤可能导致产品性能降低和/或部件磨损加速。 使用里程数、燃油消耗量、工作小时数或日历时间(以先到者为准)确定保养周期。 在恶劣作业条件下工作的产品可能需要更频密的保养。 在进行每个后续周期的保养之前,必须先进行前一个周期的所有保养。

注: 有关发电机保养建议的信息,请参考 发电机的 OEM。

需要时即进行的保养

空气预润滑泵润滑器油杯 - 清洗
蓄电池 - 回收
蓄电池 - 更换
蓄电池或蓄电池电缆 - 断开
发动机 - 清洁
发动机空气滤清器滤芯-更换
燃油系统 - 充油
燃油系统粗滤器/油水分离器 - 放水
保养建议

每天的保养

空气预润滑泵润滑器油位 - 检查
储气罐水份和沉积物-排放
蓄电池充电器 - 检查
蓄电池电解液液位 - 检查
控制面板 - 检查/测试
冷却液液位 - 检查
电气连接 - 检查
发动机空气滤清器保养指示器 - 检查
发动机机油滤清器压差 - 检查
发动机机油油位 - 检查
燃油滤清器压差 - 检查
燃油箱中的水和沉渣 - 排放
水套水加热器 - 检查
绕机检查

初次250工作小时

发动机阀间隙 - 检查

每500个工作小时的保养

冷却液液样(1 级)- 采样
冷却系统补充用冷却液添加剂(SCA)- 测试/添加
发动机机油油样 - 采样
软管和卡箍 - 检查/更换

每1000工作小时

空气切断 - 测试
冷却液液样(2 级)- 采样
发动机曲轴箱呼吸器 - 清理
发动机保护装置 - 检查

每1000个工作小时或 1 年

离心式机油滤清器 - 清洁
发动机机油和滤清器 - 更换
燃油系统粗滤器 - 清洁/检查/更换
燃油系统细滤器 - 更换

每2000工作小时

从动设备 - 检查
油雾探测器 - 检查

每3000个工作小时

曲轴减振器 - 检查
发动机安装基座 - 检查
转速传感器 - 清洁/检查
涡轮增压器 - 检查

每3000个工作小时或每3年的保养

冷却液 (DEAC) - 更换

每4000工作小时

发动机阀间隙 - 检查

每6000个工作小时或3年

冷却液长效剂(ELC)- 添加

每7000 个工作小时

预润滑泵 - 检查
起动马达 - 检查
水泵 - 检查

每10000个工作小时的保养

喷油泵 - 更换
喷油器 - 更换

每12000个工作小时数或每6年的保养

冷却液 (ELC) - 更换

每 18 000 个工作小时

冷却液温度调节器 - 更换
节温阀 - 检查

大修

后冷器芯 - 检查/清洁/测试
整体大修
大修(上部)
大修考虑事项

Caterpillar Information System:

C4.4 Engines for Caterpillar Built Machines Turbocharger - Remove - Side Mounted Turbocharger
2014/05/30 Fuel Injection Pump on Certain C3.4 Engines {1251, 1290, 5479}
C4.4 Engines for Caterpillar Built Machines Electronic Unit Injector - Install
C4.4 Engines for Caterpillar Built Machines Electronic Unit Injector - Remove
2014/08/01 New Alternator Bracket for Certain C4.4 Engines {1405, 1405}
C4.4 Engines for Caterpillar Built Machines Fuel Injection Pump Gear - Install
390F Excavator Sound Information and Vibration Information
3512C Engine Gas Shutoff Valve - Remove and Install - Dynamic Gas Blending
C13, C15, and C18 Tier 4 Final Engines Turbocharger
C4.4 Engines for Caterpillar Built Machines Pressure Sensor (NOx Reduction System) - Differential Pressure Sensor
C4.4 Engines for Caterpillar Built Machines Pressure Sensor (NOx Reduction System)
C13, C15, and C18 Generator Set Engines Turbocharger
C175-16 Petroleum Generator Set Engines Maintenance Interval Schedule - 25 Degree Tilt Option Emergency Generator Set Engine and Essential Power Units
2014/05/23 An Improved Tube Assembly Is Used on the Engine Oil Pumps of Certain C13 Commercial Engines {1304, 1315}
2015/03/25 A New Air Compressor Group Is Available for Certain Tier 4 Interim 3516C and C175 Generator Set Engines {1803}
C4.4 Engines for Caterpillar Built Machines Turbocharger - Install - Side Mounted Turbocharger
Cat® Command For Hauling Machine Swerving Is Excessive
Installation Procedure for the 493-6920 Tube Assembly on Certain C13 Commercial and Machine Engines {1304, 1315} Installation Procedure for the 493-6920 Tube Assembly on Certain C13 Commercial and Machine Engines {1304, 1315}
3512C Engine Rocker Shaft and Push Rod - Remove and Install
794 AC Off-Highway Truck Bearing (Electric Motor) - Lubricate - Drive Motor
455-1191 Top End Overhaul Foundational Kit for C18 Marine Engines{1000} 455-1191 Top End Overhaul Foundational Kit for C18 Marine Engines{1000}
3512C Engine Electronic Unit Injector - Remove and Install
C15 and C18 Engines for Caterpillar Built Machines Gear Group (Rear)
C15 and C18 Engines for Caterpillar Built Machines Alternator Mounting
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.