Rocker Shaft - Disassemble - C1.1 Engines
Disassembly Procedure
Start By:
- Remove the rocker shaft and the pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Make a temporary identification mark on each rocker arm assembly in order to show the location.
Note: Used components must be reinstalled in the original location. Do not interchange components.
- Remove plug (6) from base (10) .
Show/hide table
Illustration 1 | g01316925 |
Typical example |
- Remove O-ring seal (7) from plug (6) .
- Remove screw (9) .
- In order to remove rocker shaft (8), install a suitable bolt into the end of the rocker shaft. Use the bolt to pull the rocker shaft from base (10) .
- Remove rocker arms (3), washers (5), and springs (4) .
Show/hide table
Personal injury can result from being struck by parts propelled by a released spring force. Make sure to wear all necessary protective equipment. Follow the recommended procedure and use all recommended tooling to release the spring force. |
- Remove adjustment screws (1) and nuts (2) from rocker arms (3) .
Caterpillar Information System:
C4.4 Marine Generator Set Heat Exchanger - Assemble - Sea Water Cooled Engines
C1.1, C1.5 and C2.2 Generator Sets Inlet and Exhaust Valves - Remove and Install
C4.4 Marine Generator Set Water Pump - Remove and Install
C4.4 Marine Generator Set Valve Mechanism Cover - Remove and Install
C4.4 Marine Generator Set Turbocharger - Remove and Install
C4.4 Marine Generator Set Switch (Coolant Level) - Remove and Install - Coolant Level Switch for Keel-Cooled Engines
C4.4 Marine Generator Set Rocker Shaft and Push Rod - Remove and Install
C4.4 Marine Generator Set Rocker Shaft - Disassemble
C4.4 Marine Generator Set Rocker Shaft - Assemble
C4.4 Marine Generator Set Relief Valve (Fuel) - Remove and Install - Low Pressure System Relief Valve
C4.4 Marine Generator Set Relief Valve (Fuel) - Remove and Install - Fuel Rail Pressure Relief Valve
C4.4 Marine Generator Set Radiator - Remove and Install
C4.4 Marine Generator Set Water Temperature Regulator - Remove and Install
C1.1, C1.5 and C2.2 Generator Sets Rocker Shaft - Assemble - C1.1 Engines
390F Excavator C18 Engine Supplement Exhaust Elbow - Remove and Install
2014/08/08 New Software for Product Link PL522 Module Is Now Available for All Cat® Products {7606}
390F Excavator C18 Engine Supplement Clean Emissions Module - Remove and Install
DE Series Generator Set with Cat C1.1, C1.5, and C2.2 Engines Fuel System Primary Filter/Water Separator - Drain
DE Series Generator Set with Cat C1.1, C1.5, and C2.2 Engines Fuel System Primary Filter (Water Separator) Element - Replace
DE Series Generator Set with Cat C1.1, C1.5, and C2.2 Engines Fuel System Secondary Filter - Replace
349F and 352F Excavators Machine System Specifications Pilot Lines
349F and 352F Excavators Machine System Specifications Pilot Lines
C4.4 Marine Generator Set Relay - Test - Electric Fuel Lift Pump Relay
C3.4B Engines Injector Data Incorrect - Test