Electrical Connectors
Connectors for the Electronic Control Module (ECM)
Show/hide table
Illustration 1 | g01322554 |
Connectors for the Integrated Sensor Module (ISM)
Show/hide table
Illustration 2 | g03368616 |
40 Pin Engine Interface Connector
Show/hide table
Illustration 3 | g03382346 |
Show/hide table
Illustration 4 | g01547457 |
Show/hide table
Illustration 5 | g02751678 |
Typical connector |
Show/hide table
Illustration 6 | g01147070 |
Typical injector |
Connector at the Fuel Actuator
Show/hide table
Illustration 7 | g03368620 |
Connector at the Gas Shutoff Valve (GSOV)
Show/hide table
Illustration 8 | g03382348 |
Analog sensor connector (active)
Show/hide table
Illustration 9 | g02878221 |
Analog sensor connector (passive)
Show/hide table
Illustration 10 | g03376197 |
Show/hide table
Illustration 11 | g01155187 |
Connectors for the Termination Resistor
Show/hide table
Illustration 12 | g01355248 |
Caterpillar Information System:
CX31 and CX31 HT On-Highway Transmissions (Cat Truck) Oil Filter (Transmission)
C0.5 and C0.7 Industrial Engines Starting with Jump Start Cables
C3.4B Engines for Caterpillar Built Machines Fuel Priming Pump - Remove and Install
120 Motor Graders Magnetic Switch (Secondary Steering Relay)
C0.5 and C0.7 Industrial Engines Self-Diagnostics
LC5000, LC6100, and LC7000 Electric Power Generation Exciter Stator - Remove and Install
G3516 TA Engine Unburned Gas - Purge
G3512 Generator Set Engines Generator Output Power Sensor - Set
LC5000, LC6100, and LC7000 Electric Power Generation Terminal Box - Remove and Install
3512C Petroleum Engines with Dynamic Gas Blending Sensor Signal (Analog, Active) - Test
C280-16 Engine Aftercooler - Install
2013/05/23 A New Pressure Sensor Is Used for Certain C175-16 Commercial Engines {1439, 1919, 7400}
Installation of Cold Climate Kit for C4.4 Engine {1317, 1408} Installation of Cold Climate Kit for C4.4 Engine {1317, 1408}
C0.5 and C0.7 Industrial Engines Engine Operation
3512C Petroleum Engines with Dynamic Gas Blending Exhaust Temperature - Test
3512C Petroleum Engines with Dynamic Gas Blending Exhaust Temperature Is High
3512C Petroleum Engines with Dynamic Gas Blending Emergency Stop - Test
4-Inch Radial Hose Machine{0374, 0599, 0684, 0738, 5057} 4-Inch Radial Hose Machine{0374, 0599, 0684, 0738, 5057}
3512C Petroleum Engines with Dynamic Gas Blending Sensor Supply - Test
LC5000, LC6100, and LC7000 Electric Power Generation Bearing - Remove and Install
LC5000, LC6100, and LC7000 Electric Power Generation Diode Assembly - Remove and Install
LC5000, LC6100, and LC7000 Electric Power Generation Generator - Install
LC5000, LC6100, and LC7000 Electric Power Generation Generator - Remove
LC5000, LC6100, and LC7000 Electric Power Generation Permanent Magnet Pilot Exciter - Remove and Install - PMG