Ensure that all of the safety messages are legible. Clean the safety messages or replace the safety messages if the words cannot be read or if the illustrations are not visible. Use a cloth, water, and soap to clean the safety messages. Do not use solvents, gasoline, or other harsh chemicals. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the safety messages. The safety messages that are loosened could drop off the engine.
Replace any safety message that is damaged or missing. If a safety message is attached to a part of the engine that is replaced, install a new safety message on the replacement part. Your Cat dealer can provide new safety messages.
Illustration 1 | g06157502 |
C32 Generator Set right side view |
Illustration 2 | g06157511 |
C32 Generator Set left side view |
The safety message for electrocution is located on the right and left side of the generator. This message is also located on the rear right side of the generator.
Illustration 3 | g01392482 |
Do not connect the generator to a utility electrical distribution system unless it is isolated from the system. Electrical feedback into the distribution system can occur and could cause personal injury or death. Open and secure the main distribution switch, or if the connection is permanent, install a double throw switch to prevent electrical feedback. Some generators are specifically approved by a utility to run in parallel with the distribution system and isolation may not be required. Always check with your utility for the applicable circumstances. |
The safety message for automatic starting is located on the right and left side of the generator. This message is also located on the rear right side of the generator.
Illustration 4 | g01392484 |
When the engine is in the AUTOMATIC mode, the engine can start at any moment. To avoid personal injury, always remain clear of the the engine when the engine is in the AUTOMATIC mode. |
This safety message for crushing is located on each side of the generator.
Illustration 5 | g01433231 |
Crushing Hazard! Improper lifting could cause serious injury or death. Follow the lifting instructions in the Operation and Maintenance Manual for safe lifting procedures. |
The safety message for hot fluid under pressure is located on top of the radiator near the radiator cap.
Illustration 6 | g01371640 |
Pressurized system! Hot coolant can cause serious burns, injury or death. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. Read and understand the Operation and Maintenance Manual before performing any cooling system maintenance. |
These safety messages for hot surface are located on each side of the radiator, on each side of the engine air lines tube and on each side of the barrel of the generator.
Illustration 7 | g01384734 |
Hot parts or hot components can cause burns or personal injury. Do not allow hot parts or components to contact your skin. Use protective clothing or protective equipment to protect your skin. |
Illustration 8 | g03372069 |
These safety messages for lifting the product are located on each side of the base frame.
Before lifting the product, read this Operation and Maintenance Manual, "Product Lifting" in the Operation Section. If improper equipment is used to lift the product, injury and damage can occur. Use cables which are properly rated for the weight. Use a spreader bar and attach the cables according to the information on the safety message. |