Engine Air Cleaner Service Indicator - Inspect
The service indicator is mounted on the air cleaner.
Show/hide table
Illustration 1 | g01174131 |
(1) Service Indicator Screen |
Inspect and Clean the Indicator
Inspect the service indicator. Clean the air cleaner element or replace the element when the following conditions occur:
- The screen on the service indicator becomes red.
- Restriction of the air flowing through the air filter reaches
635 ± 58.4 mm (25 ± 2.3 inch) H2O. - The service indicator has one or more of the following:
- Cracks
- Holes
- Loose fittings
Service indicators are important instruments. Test the service indicator by using one of the following methods.
- Push the plunger into the element in order to reset. If the service indicator does not reset in three pushes or less, replace the service indicator.
- The following method can only be used when the air cleaner has been used. This test will not work immediately after cleaning the air cleaner. Push the plunger into the element. Start the engine. If the plunger does not move, replace the service indicator.
The service indicator may require frequent replacement in environments that are severely dusty. Replace the service indicator at the end of each year if the service indicator has not been replaced during the year. Replace the service indicator when the engine is overhauled. Replace the service indicator whenever major engine components are replaced.
Caterpillar Information System:
C15 Petroleum Engines Air Lines - Remove and Install
2011/06/16 Prevent Water from Entering the Turbocharger Housing of C175-16 Generator Set Engines During Storage {1052}
Break-In Procedure for the 20R-0194 Cylinder Pack Assemblies Used in C32 Marine Engines{1239} Break-In Procedure for the 20R-0194 Cylinder Pack Assemblies Used in C32 Marine Engines{1239}
C3.4B Industrial Engine Configuration Parameters
C15 Petroleum Engines Air Shutoff - Remove and Install
2011/04/29 New Communication Software with RS485 Protocol Improvement Is Now Available on Certain Cat Products {7606, 7610}
C3.4B Industrial Engine Fault Logging
C3.4B Industrial Engine Overspeed
793F and 793F CMD Off-Highway Truck Braking System Control Lever (Retarder)
Hydraulic Piston Pumps Used in Certain Models of Caterpillar Equipment{3203, 5070, 5084} Hydraulic Piston Pumps Used in Certain Models of Caterpillar Equipment{3203, 5070, 5084}
2011/04/08 New Oil Pump Shaft for C1.5 and C2.2 Engines {1204, 1212, 1234, 1304, 1361}
C3.4B Engines For Caterpillar Built Machines Engine Oil Pump
C7.1-XQ200 Rental Generator Set Product Description
C15 Petroleum Engines Crankcase Breather - Remove and Install
C27 Generator Set Sound Information
C15 Petroleum Engines Aftercooler - Disassemble
C15 Petroleum Engines Component Location
C18 Marine Auxiliary and Marine Generator Set Engines Cylinder Liner Projection - Inspect
G3500 A3 Engines Throttle Control Linkage
C15 Petroleum Engines Coolant Level - Check
C15 Petroleum Engines Air Shutoff - Test
C27 Generator Set Generator Set - Test
Reusability Guidelines and Installation Procedures for Split Master Links {4170, 4176} Reusability Guidelines and Installation Procedures for Split Master Links {4170, 4176}
C15 Petroleum Engines Aftercooler - Assemble