Basic Preventive Maintenance
Perform the following basic preventive maintenance procedures yearly.
- Unit Initial Check
- Metering - Check
- System Shutdown
- Configuration - Check
- Cabinet - Check
- Unit Final Check
These procedures are part of the general recommended preventive maintenance program. These procedures should only be performed by a qualified technician who has been trained to maintain this product.
If a problem is identified at any time during a preventive maintenance procedure, do not proceed with the procedure until the problem is resolved.
Caterpillar Information System:
3512B Petroleum Engines with the ADEM 2 Electronic Control Module E012 High Crankcase Pressure Derate
C27 and C32 Engines for Caterpillar Built Machines Exhaust Sensor Lines - Remove and Install
312F and 313F Excavators Belt - Inspect/Adjust/Replace
3306B Generator Set Safety Messages
3306B Generator Set Generator Bearing Temperature - Measure/Record
3500B Generator Sets Generator Bearing - Lubricate
3306B Generator Set Alternator and Fan Belts - Inspect/Adjust/Replace
3306B Generator Set Generator Bearing - Inspect
3306B Generator Set Refill Capacities and Recommendations
793F and 797F Off-Highway Trucks Chassis Electronic Control System Backlight Does Not Illuminate
C3.4B Engines Diesel Particulate Filter Collects Excessive Soot
C3.4B Engines Coolant Level Is Low
UPSB125 Uninterruptible Power Supply UPS Battery - 50Hz Advanced Preventive Maintenance
C3.4B Engines Diesel Particulate Filter Temperature Is Low
120 and 120 AWD Motor Grader Braking System - Test
793F and 797F Off-Highway Trucks Chassis Electronic Control System Backlight Is On Continuously
Retrofitting for Ultra Lean Burn (ULB) on Certain G3516 Engines{1000, 775E} Retrofitting for Ultra Lean Burn (ULB) on Certain G3516 Engines{1000, 775E}
312F and 313F Excavators Engine Oil Level - Check
C27 and C32 Industrial Engines Exhaust Gas Valve (NRS) - Remove and Install
320E and 323E Excavators Fuel System Primary Filter (Water Separator) Element - Replace
C3.4B Engines Engine Has Early Wear
Replacing the High Pressure Fuel Pump on Certain C7 and C9 Engines{1251, 1714} Replacing the High Pressure Fuel Pump on Certain C7 and C9 Engines{1251, 1714}
312F and 313F Excavators Fumes Disposal Filter Element - Replace
C27 and C32 Engines for Caterpillar Built Machines Air Inlet Elbow - Remove and Install