Engine Oil Pump - Remove and Install
开始:
- 拆下发动机油底壳。
- 拆下螺栓 (5) 和 (7)。 拆下吸油管 (6)。
- 拆下螺栓 (3),然后拆下管组件 (4)。
- 拆下螺栓 (1),然后拆下发动机机油泵 (2)。
Show/hide table
图 1 | g02149920 |
- 按与拆卸相反的顺序安装发动机机油泵 (2)。
注: 清洁度是一项重要的因素。 组装之前,应使用清洁液体彻底清洁所有零件。 让零件风干。 不要使用抹布擦干零件。 棉绒可能会留在零件上,可能导致以后出现故障。 检查所有零件。 如果任何零件磨损或损坏,则应使用新零件进行更换。
注: 检查 O 形密封圈、垫片和密封件有无磨损或损坏。 如有必要,请更换部件。
Caterpillar Information System:
797F and 797F XQ Off-Highway Trucks Machine Systems Piston Pump (Brake Cooling) - Remove and Install
C18 Marine Engine Sensors and Electrical Components - Engines with 1000 HP or Greater
3612 and 3616 Fast Vessel Engines Customer Assistance
C4.4 Industrial Engine Position the Valve Mechanism Before Maintenance Procedures
797F and 797F XQ Off-Highway Trucks Machine Systems Gear Pump (Brake, Rear Axle Lubrication) - Remove and Install
C6.6 Industrial Engine Position the Valve Mechanism Before Maintenance Procedures
C6.6 Industrial Engine Fuel Injection Pump Gear - Remove
C6.6 Industrial Engine Fuel Injection Pump - Install
Procedure to Install a New Software with Droop Capability for Load Sharing on Certain C11 and C15 Industrial Engines{1901, 1920} Procedure to Install a New Software with Droop Capability for Load Sharing on Certain C11 and C15 Industrial Engines{1901, 1920}
C6.6 Industrial Engine Fuel Injection Pump - Remove
C6.6 Industrial Engine Inlet Air Control - Install - NRS Inlet Air Mixer
C6.6 Industrial Engine Inlet Air Control - Remove - NRS Inlet Air Mixer
797F and 797F XQ Off-Highway Trucks Machine Systems Piston Pump (Hydraulic Fan, Steering) - Remove and Install
C13 Tier 4 Final Engines Soot Antenna
C6.6 Industrial Engine Fuel Injection Pump Gear - Install
G3520E Generator Set Engines Turbocharger Oil Lines
C6.6 Industrial Engine Electronic Unit Injector - Remove
C6.6 Industrial Engine Electronic Unit Injector - Install
C6.6 Industrial Engine Wastegate Solenoid - Remove and Install
C6.6 Industrial Engine Inlet and Exhaust Valve Springs - Remove and Install
G3512E Generator Set Engines Exhaust Fitting
C6.6 Industrial Engine Inlet and Exhaust Valves - Remove and Install
C6.6 Industrial Engine Engine Oil Filter Base - Remove and Install
C6.6 Industrial Engine Engine Oil Cooler - Remove - Engine Oil Cooler with a Low Mounted Filter Base