Fuel Injection Pump Gear - Remove
Show/hide table
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | - | Puller (Two Legged) | 1 |
| B | - | E10 Torx Socket 1/4" Square Drive |
1 |
Start By:
- Remove the fuel injection pump. Refer to Disassembly and Assembly, "Fuel Injection Pump - Remove" for the correct procedure.
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Dispose of all fluids according to local regulations and mandates. |
- Use a suitable tool in order to prevent fuel injection pump gear (3) from rotating.
Note: Do not use timing pin for the fuel injection in order to prevent the fuel injection pump gear from rotating.
- Remove nut (1) and washer (2).
- Use Tooling (A) in order to remove gear (3) from the shaft of fuel injection pump (7).
- Remove key (6) from the shaft of fuel injection pump (7).
- Use Tooling (B) in order to remove Torx screws (8) and the washers.
- Remove adapter plate (4) from fuel injection pump (7).
- Remove O-ring seal (5).
Show/hide table
| |
| Illustration 1 | g01970674 |
Caterpillar Information System:
C6.6 Industrial Engine Fuel Injection Pump - Install
Procedure to Install a New Software with Droop Capability for Load Sharing on Certain C11 and C15 Industrial Engines{1901, 1920} Procedure to Install a New Software with Droop Capability for Load Sharing on Certain C11 and C15 Industrial Engines{1901, 1920}
C6.6 Industrial Engine Fuel Injection Pump - Remove
C6.6 Industrial Engine Inlet Air Control - Install - NRS Inlet Air Mixer
C6.6 Industrial Engine Inlet Air Control - Remove - NRS Inlet Air Mixer
C6.6 Industrial Engine Fuel Injection Lines - Install
G3520E Generator Set Engines Air Lines
C6.6 Industrial Engine Fuel Injection Lines - Remove
C6.6 Industrial Engine Fuel Manifold (Rail) - Remove and Install
C6.6 Industrial Engine Fuel Filter Base - Remove and Install - Single Secondary Fuel Filter
C6.6 Industrial Engine Fuel Priming Pump - Remove and Install - Electric Fuel Lift Pump (EFLP)
C4.4 Industrial Engine Crankshaft Pulley - Check
C6.6 Industrial Engine Position the Valve Mechanism Before Maintenance Procedures
797F and 797F XQ Off-Highway Trucks Machine Systems Gear Pump (Brake, Rear Axle Lubrication) - Remove and Install
C4.4 Industrial Engine Position the Valve Mechanism Before Maintenance Procedures
3612 and 3616 Fast Vessel Engines Customer Assistance
C18 Marine Engine Sensors and Electrical Components - Engines with 1000 HP or Greater
797F and 797F XQ Off-Highway Trucks Machine Systems Piston Pump (Brake Cooling) - Remove and Install
C9.3 Engines for Caterpillar Built Machines Engine Oil Pump - Remove and Install
797F and 797F XQ Off-Highway Trucks Machine Systems Piston Pump (Hydraulic Fan, Steering) - Remove and Install
C13 Tier 4 Final Engines Soot Antenna
C6.6 Industrial Engine Fuel Injection Pump Gear - Install
G3520E Generator Set Engines Turbocharger Oil Lines
C6.6 Industrial Engine Electronic Unit Injector - Remove