Illustration 1 | g01950256 |
Note: Lubricate the gear pump group with clean oil before you operate. The gear pump group must rotate freely by using your hand.
(1) Section for transmission scavenge
- Rotation ... Counterclockwise
- Test speed ... 1800 rpm
- Test pressure ...
70 kPa (10 psi) - Minimum flow ...
856.0 L/min (226.1 US gpm) - Test speed ... 1800 rpm
(2) Section for transmission charging
- Rotation ... Counterclockwise
- Test speed ... 1800 rpm
- Test pressure ...
3100 kPa (450 psi) - Minimum flow ...
296.0 L/min (78.2 US gpm) - Test speed ... 1800 rpm
(B) Diameter of the new shaft of the gear ...
(C) Distance from end of four dowels to the face of the oil pump body assembly (3) ...
Note: Make sure that the gear (4) slides freely on two woodruff keys (5).
Illustration 2 | g01950258 |
Detail D (7) Oil pump body assembly |
(H) Location of the joints of six sleeve bearings from the vertical centerline ... 30 ± 15 degrees
(6) 262-0562 Sleeve Bearing
- Inside diameter ...
50.918 ± 0.040 mm (2.0046 ± 0.0016 inch) - Outside diameter ...
55.732 ± 0.025 mm (2.1942 ± 0.0010 inch) - Outside diameter ...
(J) Installation depth of four sleeve bearings (6) ...
Illustration 3 | g01950264 |
Detail E |
(L) Distance from end of the sleeve (8) to the face of the cover assembly (9) ...
Illustration 4 | g06249746 |
Detail F |
(N) Distance from end of two dowels to the face of the cover assembly (10) ...
(11) 455-1875 Sleeve Bearing
- Outside diameter ...
57.226 ± 0.013 mm (2.2530 ± 0.0005 inch) - Thickness ...
3.116 ± 0.013 mm (0.1227 ± 0.0005 inch) - Thickness ...
(P) Installation depth of two sleeve bearings (11) ...