Temperature Sensor (Cooled Exhaust Gas) - Remove and Install
Show/hide table
Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | 5P-3931 | Anti-Seize Compound | 1 |
- Disconnect the harness assembly (1) and remove temperature sensor (2).
Show/hide table
Illustration 1 | g01882934 |
- Install temperature sensor (2) in reverse order of removal.
- Apply Tooling (A) to threads of temperature sensor (1).
- Tighten temperature sensor (1) to a torque of
45 ± 5 N·m (33 ± 4 lb ft) .
Caterpillar Information System:
C13 Engines for Caterpillar Built Machines Inlet Manifold - Remove and Install
C4.4 Industrial Engine Battery - Replace
C9.3 Engines for Caterpillar Built Machines Diagnostic Capabilities
C13 Engine for Caterpillar Built Machines Cylinder Head - Remove and Install
2009/04/01 Reworked Air Compressors Now Have "R" on the Serial Number Plate {1803, 1804}
2009/04/13 Reworked Air Compressors Now Have "R" on the Serial Number Plate {1803, 1804}
C6.6 Industrial Engine Refill Capacities and Recommendations
C7.1 Industrial Engine and Generator Set Valve Lash Is Excessive
C15 and C18 Industrial Engines Diesel Particulate Filter - Remove and Install - Clean Emissions Module
C18 Power Module Maintenance Interval Schedule - Standby
C18 Power Module Maintenance Interval Schedule
C7.1 Industrial Engine and Generator Set Cylinder Is Noisy
C13 Engines for Caterpillar Built Machines Temperature Sensor (Aftercooler Air) - Remove and Install
C13 Engines for Caterpillar Built Machines Pressure Sensor (Cooled Exhaust Gas) - Remove and Install
C13 Engines for Caterpillar Built Machines Pressure Sensor (Cooled Exhaust Gas) - Remove and Install - Differential Pressure Sensor
C7.1 Industrial Engine Engine Crankcase Breather Element - Replace
C13, C15, and C18 Tier 4 Interim Engines ARD Nozzle - Test
C13 Engine Fuel Transfer Pump - Remove
C13 Engine Fuel Transfer Pump - Install
C13 Engine Electronic Unit Injector - Remove
C13 Engine Electronic Unit Injector - Install
C13 Engine Electronic Unit Injector Sleeve - Remove
C13 Engine Electronic Unit Injector Sleeve - Install
C7.1 Industrial Engine and Generator Set Electrical Connectors - Inspect