Glow Plugs
Show/hide table
Illustration 1 | g01861335 |
Typical example |
Tighten the glow plugs (2) in the cylinder head to the following torque. ...
Tighten the nuts (1) for the bus bar (3) that is installed on top of the glow plugs to the following torque. ...
Tighten the nut (4) for the isolator for the bus bar to the following torque. ...
Voltage ... 12 V or 24 V
Caterpillar Information System:
C13 Engines for Caterpillar Built Machines Rocker Arm and Shaft - Install
C6.6 Industrial Engine Valve Mechanism Cover
C6.6 Industrial Engine Crankcase Breather
C13 Engines for Caterpillar Built Machines Rocker Arm and Shaft - Remove
C6.6 Industrial Engine Electronic Control Module
C7.1 Industrial Engine Turbocharger - Series Turbochargers
C6.6 Industrial Engine Front Housing and Covers
C13 Engine for Caterpillar Built Machines Electronic Unit Injector Sleeve - Remove and Install
C9.3 Tier 4 Interim Engines Oil Contains Fuel
C9.3 Engines for Caterpillar Built Machines Oil Pressure Is Low
C13 Engine for Caterpillar Built Machines Fuel Pressure Regulator - Remove and Install
C6.6 Industrial Engine Boost Pressure Sensor
C4.4 Industrial Engine Fuel Injection Nozzles
C13 Engine for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install
C13 Engine for Caterpillar Built Machines Valve Mechanism Cover Base - Remove and Install
C7.1 Engines for Caterpillar Built Machines Crankshaft
C11 and C13 Engines Fuel Pressure Sensor
C12 Marine Engines Fuel Injector - Inspect/Adjust
824K Wheel Dozer, 825K Soil Compactor and 826K Landfill Compactor Machine Systems Magnetic Switch
2009/05/11 A New Wiring Harness for the Space Heater Is Used {1408, 664E}
C12 Marine Engines Engine Speed/Timing Sensor - Clean/Inspect
C15 and C18 Industrial Engines Inlet Air Temperature Sensor - Remove and Install
C12 Marine Engines Emissions Certification Film
C6.6 Industrial Engine Exhaust Cooler (NRS)