Crankcase Breather
Show/hide table
Illustration 1 | g02295333 |
Typical example |
(1) ( 2) ( 3) Tighten the setscrews to the following torque. ...
(4) Tighten the setscrews to the following torque. ...
Note: If a hexagonal pillar spacer is required, install the spacer to the engine oil cooler. Tighten the spacer to a torque of
Caterpillar Information System:
C13 Engines for Caterpillar Built Machines Rocker Arm and Shaft - Remove
C6.6 Industrial Engine Electronic Control Module
C7.1 Industrial Engine Turbocharger - Series Turbochargers
C6.6 Industrial Engine Front Housing and Covers
C13 Engine for Caterpillar Built Machines Electronic Unit Injector Sleeve - Remove and Install
C9.3 Tier 4 Interim Engines Oil Contains Fuel
C9.3 Engines for Caterpillar Built Machines Oil Pressure Is Low
C13 Engine for Caterpillar Built Machines Fuel Pressure Regulator - Remove and Install
C6.6 Industrial Engine Boost Pressure Sensor
CX31-P600 Petroleum Transmission Well Servicing Modulating Valve (Transmission Clutch) - Remove and Install
CX35-P800 Petroleum Transmission and Petroleum Power Train Packages Modulating Valve (Transmission Clutch) - Remove and Install
C13 Engines for Caterpillar Built Machines Engine Oil Filter Base - Assemble
C6.6 Industrial Engine Valve Mechanism Cover
C13 Engines for Caterpillar Built Machines Rocker Arm and Shaft - Install
C7.1 Engines for Caterpillar Built Machines Glow Plugs
C4.4 Industrial Engine Fuel Injection Nozzles
C13 Engine for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install
C13 Engine for Caterpillar Built Machines Valve Mechanism Cover Base - Remove and Install
C7.1 Engines for Caterpillar Built Machines Crankshaft
C11 and C13 Engines Fuel Pressure Sensor
C12 Marine Engines Fuel Injector - Inspect/Adjust
824K Wheel Dozer, 825K Soil Compactor and 826K Landfill Compactor Machine Systems Magnetic Switch
2009/05/11 A New Wiring Harness for the Space Heater Is Used {1408, 664E}
C12 Marine Engines Engine Speed/Timing Sensor - Clean/Inspect