1987/08/24 Caterpillar

New 8T8726, 8T8694 And 8T8695 Adapter Cable Assemblies Available{0600}

Usage:

3406B (PEEC) Engines

SUPPLEMENT: 06/13/88

SERVICE MAGAZINE; AUGUST 24, 1987; PAGE 18; "New 8T8726, 8T8694 And 8T8695 Adapter Cable Assemblies Available" for 3406B (PEEC) Engines. In the illustration, the part number, 8T9695, is not correct. The correct part number is 8T8695.

--------------- END SUPPLEMENT ---------------

The new 8T8726 (3-pin breakout), 8T8694 (5-pin breakout) and 8T8695 (9-pin breakout) Adapter Cable Assemblies are available to help service 3406B (PEEC) Engines. These three cable assemblies will provide test points for the individual wires in the wiring harness used for the PEEC System. This will facilitate troubleshooting of the PEEC System. The cable assemblies are essentially "T" cables with individual tip jacks on the pigtail portion of the cables. The cable assemblies may be inserted into the PEEC System wiring harness at connector locations. The individual tip jacks on the pigtails are labeled the same as the wires to which they are connected in the PEEC System wiring harness. Standard probe tips, such as those used on multimeter leads, can be inserted into the tip jacks.

NOTE: The 8T8726 Adapter Cable Assembly (3-pin breakout) is included in the 8T5282 PEEC Digital Diagnostic Tool Group.

Adapter cable assemblies.

Caterpillar Information System:

1987/08/24 New 8T5282 Programmable Electronic Engine Control Digital Diagnostic Tool Group (PEEC DDT) Available{0600}

1987/08/24 New 8T8697 Electronic Control Analyzer Programmer (ECAP), 8C5919 Electronic (ECAP PEEC) Conversion Group and 8T5275 Adapter Cable Assembly (T-Harness Cable) Available{0600}

1987/08/24 Dynamic Timing Charts Available For Most Popular 3208 And 3406 Truck Engine Ratings{1272}

1987/08/24 Additional Engine Tilt Installation Angles And Engine Dipstick Markings{1326}

1987/08/24 Engine Oil Refill Capacity Decreased{1213,1326}

1987/08/24 Improved High Temperature Seals Available{1252,1120}

1987/08/24 More Accurate And Easier Method To Adjust 8T1815 Or 6L5438 Main Shaft Bearing{3306,3351}

1987/08/10 Remanufactured Turbocharger Groups And Cartridges{1052,1053}

1987/08/10 Fuel Heaters Should Be Thermostatically Controlled Or Self-Regulated{1250,1260,1296}

1987/08/10 Improved Gaskets Used In Central Structure Cover Groups, Jacket Water Lines Groups, Jacket Water Heater Groups And Water Aftercooler Groups{1350,1063}

1987/08/03 New Caterpillar Sea Trial Rules Of Thumb Pocket Reference Card {0372}

1987/08/03 Temperature Regulator Housing Parts And Water Pump Adapter Have More Resistance To Erosion And Galvanic Corrosion; Guidelines On Grounding Of Electrical System And Cooling System Maintenance {1350,1361,1393,1400}

1987/08/31 Improved Clutch Piston And Retraction Pins Available {3302}

1987/08/31 Recommendations For Preventing Cooling System Damage {1201}

1987/08/31 Metal Protectors Replace Plastic Protectors On Head Studs {1100}

1987/09/07 Improved Warranty For Remanufactured Parts And Components{7754}

1987/09/07 Use The Marketing Publications Information Feedback System{0374}

1987/09/07 Be Sure To Correctly Tighten Turbocharger Clamp Assemblies{1052}

1987/09/07 New O-Ring Seals Used In Water Lines{1350}

1987/09/14 Remanufactured Air Conditioner Compressor Available {1802}

1987/09/14 Four More Remanufactured Fuel Pump And Governor Groups Available {1286}

1987/09/14 Remanufactured 3208T Economy Truck Engine Available {1000}

1987/09/14 New Turbochargers Have Several Improvements {1053,1066}

1987/09/14 Mid-Life Bearing Maintenance Recommendations {1203}