Fuel Priming Pump - Disassemble
Disassembly Procedure
Start By:
- Remove the fuel priming pump. Refer to Disassembly and Assembly, "Fuel Priming Pump - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove handle (1) .
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
Show/hide table
Illustration 1 | g00618482 |
- Use a paint stick to put alignment marks across head (2) and pump cylinder (3) .
Show/hide table
Illustration 2 | g00618484 |
- Remove the bolts and head (2) from pump cylinder (3) .
- Remove shaft (4) from head (2) .
Show/hide table
Illustration 3 | g00618486 |
- Remove lip seal (5) from head (2) .
Show/hide table
Illustration 4 | g00618488 |
- Remove rotor (6), vanes (7), and the springs from the pump cylinder.
Show/hide table
Illustration 5 | g01303866 |
Show/hide table
Personal injury can result from parts and/or covers under spring pressure. Spring force will be released when covers are removed. Be prepared to hold spring loaded covers as the bolts are loosened. |
- Remove O-ring seal (8) from the pump cylinder.
Caterpillar Information System:
C15 and C18 Petrolem Generator Set Engines Sensor Signal (Analog, Active) - Test
3608 Engine Fuel Injector - Install
3608 Engine Fuel Injector - Remove
3608 Engine Governor Drive - Assemble - Later
Specifications and Reusability for Hydraulic Gear Pumps and Motors (Groups 1, 2, and 3) {5061, 5073} Specifications and Reusability for Hydraulic Gear Pumps and Motors (Groups 1, 2, and 3) {5061, 5073}
3176C and 3196 Engines for Caterpillar Built Machines Belt Tensioner
3500B and 3500C Marine Propulsion Engines Engine Will Not Crank
3608 Engine Governor - Install
3608 Engine Governor - Remove
3608 Engine Crankcase Explosion Relief Valve - Remove and Install
C-10 and C-12 Truck Engines Exhaust Manifold
C-10 and C-12 Truck Engines Exhaust Manifold
3608 Engine Fuel Priming Pump - Assemble
3608 Engine Fuel Transfer Pump - Install
3608 Engine Air Inlet Shutoff - Remove and Install
C15 and C18 Petrolem Generator Set Engines Sensor Signal (Analog, Passive) - Test
3608 Engine Exhaust Manifold - Remove and Install
Procedure to Update a Standard TH48-E80 Oil/Gas Transmission to a Warm-Up Mode TH48-E80 Oil/Gas Transmission{1408, 3083, 3160, 3168, 4800, 7610} Procedure to Update a Standard TH48-E80 Oil/Gas Transmission to a Warm-Up Mode TH48-E80 Oil/Gas Transmission{1408, 3083, 3160, 3168, 4800, 7610}
3608 Engine Turbocharger - Remove
3608 Engine Turbocharger - Disassemble
3608 Engine Turbocharger - Assemble
3608 Engine Turbocharger - Install
C175-16 and C175-20 Generator Set Engines Cylinder Head
14L Motor Grader Machine Systems Circle - Remove