D6K and D6K2 Track-Type Tractor Monitoring System Caterpillar

Procedure

1. Replace the module.

   1. Turn the key start switch to the OFF position.

   2. Disconnect the machine harness from the module.

   3. Ensure that the new module has the correct part number.

   4. Install the new module.

   5. Connect the machine harness to the module. If applicable, make sure that the harness code plug is installed.

   6. Turn the disconnect switch and the key start switches to the ON position. Make sure that the module successfully completes the self-test.

      Expected Result

      The module has been successfully replaced and the module has completed the self-test.

      Results

      • YES - The module has been successfully replaced and has completed the self-test. Proceed to Step 2.

      • NO - The module has been successfully replaced but has not performed the self-test properly. Ensure that the module is correct. Make sure that the installation is correct and that no related diagnostic codes are present.

      STOP.

2. Setup

   1. Set up the optional display modules. See Systems Operation, "Display Menu".

   2. Set the desired units (English or Metric). See System Operation, "Display Menu".