Start By:
- Connect the steering frame lock.
- Drain the coolant from the cooling system.
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
 |
|
Personal injury can result from hot coolant, steam and alkali. At operating temperature, engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot coolant or steam. Any contact can cause severe burns. Remove filler cap slowly to relieve pressure only when engine is stopped and radiator cap is cool enough to touch with your bare hand. Cooling System Conditioner contains alkali. Avoid contact with skin and eyes. |
Note: Cleanliness is an important factor. Before the removal procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and helps to keep contaminants from entering the system.
| |
| Illustration 1 | g06110360 |
| |
| Illustration 2 | g06110973 |
| |
| Illustration 3 | g06110974 |
| |
| Illustration 4 | g06110976 |
| |
| Illustration 5 | g06110977 |
| |
| Illustration 6 | g06110978 |
| |
| Illustration 7 | g06110979 |
- Install the water temperature regulator in reverse order of removal.