Front Cover - Remove and Install
拆卸步骤
开始:
- 如果发动机配备一个风扇,拆下该风扇。 请参阅拆解和组装, "风扇 - 拆卸和安装"。
- 拆下水泵。 请参阅拆解和组装, "水泵 - 拆卸"。
Show/hide table
注意 |
---|
在检验、保养、测试、调整及维修产品时,务必留心,确保液体盛装在容器中。 在打开任何腔室或拆解任何储有液体的部件之前,要准备好用合适的容器收集液体。 按照本地法规和指令处置所有液体。 |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
注: 要卸下前盖,不需要卸下曲轴皮带轮或交流发电机。
- 卸下螺栓 (3) 、 (4) 和 (5) 。 确定不同螺栓的位置。
Show/hide table
图 1 | g01258462 |
典型示例 |
- 将前盖 (1) 从前壳体上拆下。
- 将接头 (2) 从前盖 (1) 上拆下。
安装步骤
Show/hide table
所需工具     | |||
工具     | 零件号     | 零件描述     | 数量     |
A     | -     | 导向螺栓 (M8 × 80 mm)     |
2     |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 彻底清洁前壳体的配合面。
Show/hide table
图 2 | g01343967 |
典型示例 |
- 如果安装原来的前盖,遵循步骤 2.a 和 2.b,安装接头。
- 彻底清洁前盖。
- 将新接头 (2) 安装到前盖 (1) 上。 在前盖的孔中啮合定位工具 (Y) 。
- 将工具 (A) 安装到前壳体的孔 (X) 中。
- 使用工具 (A) 将前盖组件安置到前壳体上。
- 安装螺栓 (3) 、 (4) 和 (5) ,用手拧紧。 确保不同螺栓的安装位置正确。
- 松散地安装水泵组件并拆卸工具 (A) 。 请参阅拆解和组装, "水泵 - 安装",以了解正确的步骤。
- 拧紧螺母 (3) 、 (4) 和 (5) 至扭矩为 22 N·m (16 lb ft)。
- 拧紧水泵的螺栓至扭矩为 22 N·m (16 lb ft)。
End By: 如果发动机配备风扇,安装该风扇。 请参阅 拆解和组装, "风扇 - 拆卸和安装"。
Caterpillar Information System:
C15 and C18 Industrial Engines Engine Top Speed Is Not Obtained
C15 and C18 Industrial Engines Engine Misfires, Runs Rough or Is Unstable
3512C Industrial Engine Fuel Transfer Pump - Install
3512C Industrial Engine Fuel Transfer Pump - Remove
C15 and C18 Industrial Engines Inlet Air Is Restricted
C15 and C18 Industrial Engines Cat Data Link - Test
3512C Engine Sensor Signal (PWM) - Test
Procedure to Inspect Machines Potentially Damaged Due to Water Submersion{1000, 7000} Procedure to Inspect Machines Potentially Damaged Due to Water Submersion{1000, 7000}
3512C Engine Sensor Signal (Analog, Passive) - Test
C7 and C9 On-Highway Engines Clean Gas Induction - Test
C7 and C9 On-Highway Engines ARD Ignition - Test
C7 and C9 On-Highway Engines ARD Fuel Pressure - Test
C4.4 (MECH) Industrial Engine and Generator Sets Gear Group (Front) - Remove and Install
C4.4 (MECH) Industrial Engine and Generator Sets Vacuum Pump - Remove and Install
3408C and 3412C Marine Engines Alternator and Regulator
C32 Marine and Auxiliary Marine Engines Auxiliary Water Pump
C7 and C9 Petroleum Engines Speed/Timing - Test
C7 and C9 Petroleum Engines Switch Circuits - Test
C7 and C9 On-Highway Engines Coolant Level Is Low
3512C Engine Sensor Supply - Test
C7 and C9 On-Highway Engines Coolant Temperature Is High
C7 and C9 On-Highway Engines Oil Contains Fuel
C7 and C9 Petroleum Engines Customer Passwords
C32 Petroleum Engines Safety Messages