Inlet Air Is Restricted
Use this procedure if the following event code is active. Refer to Troubleshooting, "Event Code List" for information about event codes and the default trip points for these codes. You must access the monitoring system on Caterpillar Electronic Technician (ET) in order to view the current trip points for these codes.
Show/hide table
Event Code     | ||
---|---|---|
Code and Description     | Conditions which Generate this Code     | System Response     |
E272(1) Inlet Air Restriction Warning     | The inlet air restriction is above the trip point pressure for the delay time.     | The code is logged.     |
E031(2) Air Filter Restriction Derate     | The engine is derated. The code is logged. |
Probable Causes
- Air filter element
Recommended Actions
Air Filter Element
Check the air intake system for plugged air filters or for damaged air filters. If the engine is equipped with an air intake precleaner, verify the proper operation of the air intake precleaner.
Caterpillar Information System:
C15 and C18 Industrial Engines Cat Data Link - Test
3512C Engine Sensor Signal (PWM) - Test
Procedure to Inspect Machines Potentially Damaged Due to Water Submersion{1000, 7000} Procedure to Inspect Machines Potentially Damaged Due to Water Submersion{1000, 7000}
3512C Engine Sensor Signal (Analog, Passive) - Test
C7 and C9 On-Highway Engines Clean Gas Induction - Test
C7 and C9 On-Highway Engines ARD Ignition - Test
C7 and C9 On-Highway Engines ARD Fuel Pressure - Test
C4.4 (MECH) Industrial Engine and Generator Sets Air Compressor - Remove and Install
C4.4 (MECH) Industrial Engine and Generator Sets Electric Starting Motor - Remove and Install
C4.4 (MECH) Industrial Engine and Generator Sets Alternator - Install - Engines With an Automatic Belt Tensioner
C4.4 (MECH) Industrial Engine and Generator Sets Alternator - Remove - Engines With an Automatic Belt Tensioner
C4.4 (MECH) Industrial Engine and Generator Sets Alternator - Install - Engines Without an Automatic Belt Tensioner
3512C Industrial Engine Fuel Transfer Pump - Remove
3512C Industrial Engine Fuel Transfer Pump - Install
C15 and C18 Industrial Engines Engine Misfires, Runs Rough or Is Unstable
C15 and C18 Industrial Engines Engine Top Speed Is Not Obtained
C4.4 (MECH) Industrial Engine and Generator Sets Front Cover - Remove and Install
C4.4 (MECH) Industrial Engine and Generator Sets Gear Group (Front) - Remove and Install
C4.4 (MECH) Industrial Engine and Generator Sets Vacuum Pump - Remove and Install
3408C and 3412C Marine Engines Alternator and Regulator
C32 Marine and Auxiliary Marine Engines Auxiliary Water Pump
C7 and C9 Petroleum Engines Speed/Timing - Test
C7 and C9 Petroleum Engines Switch Circuits - Test
C7 and C9 On-Highway Engines Coolant Level Is Low