Fuel Injector Cover - Remove and Install
拆卸步骤
Show/hide table
| 注意 |
|---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 彻底清洁盖 (1) 的所有外表面。
Show/hide table
 | |
| 图 1 | g01319811 |
典型示例 | |
- 将螺栓 (2) 从盖 (1) 上拆下。
- 拆下盖 (1) 。
安装步骤
Show/hide table
| 注意 |
|---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 彻底清洁盖 (1) 的所有内表面。
Show/hide table
| | |
| 图 2 | g01319811 |
典型示例 | |
- 安装盖 (1) 。
- 安装螺栓 (2) 。 拧紧螺栓 (2) 至扭矩为 9 N·m (7 lb ft)。
Caterpillar Information System:
C4.4 (MECH) Industrial Engine and Generator Sets Fuel Injection Lines - Remove and Install
C4.4 (MECH) Industrial Engine and Generator Sets Fuel Priming Pump and Fuel Filter Base - Remove and Install
3512C Engine Injector Solenoid - Test
3512C Engine Plate Locations and Film Locations
2007/08/27 A New Temperature Gauge is Used {7450}
C7 and C9 Petroleum Engines Speed Control (Switch) - Test
C15 and C18 Industrial Engines Electrical Power Supply - Test
C7 Marine Engine Fuel Filter Base
C7 and C9 On-highway Engines Compression Brake - Caterpillar Compression Brake (if equipped)
C15 and C18 Industrial Engines Sensor Signal (Analog, Passive) - Test
C7 and C9 Petroleum Engines Sensor Signal (Analog, Active) - Test
2007/06/04 A Dye is Now Added to the Engine Oil at the Factory {1348}
C4.4 (MECH) Industrial Engine and Generator Sets Fuel Injector - Remove
C4.4 (MECH) Industrial Engine and Generator Sets Fuel Injector - Install
C4.4 (MECH) Industrial Engine and Generator Sets Fuel Injection Pump Gear - Remove
C4.4 (MECH) Industrial Engine and Generator Sets Fuel Injection Pump Gear - Install
3512C Industrial Engine Electric Starting Motor - Remove and Install
C7 and C9 Petroleum Engines Sensor Signal (Analog, Passive) - Test
C32 Marine Propulsion Engines Exhaust Temperature Is High
3512C Engine Oil Renewal - Test
3512C Engine Prelubrication - Test
3512C Engine Protection Override - Test
C32 Marine Propulsion Engines Oil Temperature Is High
C32 Marine Propulsion Engines Coolant Level Is Low