Fuel Filter Base
Show/hide table
Illustration 1 | g01382586 |
Typical example |
(A) Put 154-9731 Thread Lock Compound on the tapered end of the stud to the following distance. ... 7.6 ± 1.5 mm (.30 ± .06 inch)
(B) Distance from the sealing surface of the filter base to the end of the stud ... 24.7 ± 2.3 mm (0.97 ± 0.09 inch)
(C) Sealing surface of the stud
Note: Do not damage this surface.
(1) Torque for stud ... 68 ± 7 N·m (50.15 ± 5.16 lb ft)
Caterpillar Information System:
C7 and C9 On-highway Engines Compression Brake - Caterpillar Compression Brake (if equipped)
C15 and C18 Industrial Engines Sensor Signal (Analog, Passive) - Test
C7 and C9 Petroleum Engines Sensor Signal (Analog, Active) - Test
2007/06/04 A Dye is Now Added to the Engine Oil at the Factory {1348}
2007/06/04 A Dye is Now Added to the Engine Oil at the Factory {1348}
C6.6 Industrial Engine Belt Tensioner - Inspect
C7 and C9 Petroleum Engines Injector Solenoid - Test
C7 and C9 Petroleum Engines Injection Actuation Pressure Control Valve - Test
C15 and C18 Industrial Engines Sensor Supply - Test
3512C Engine Safety Messages
2007/05/28 Elevated Levels of Engine Power {1901, 1902, 7620}
3512C Engine Fuel Position Multiplier - Test
C15 and C18 Industrial Engines Electrical Power Supply - Test
C7 and C9 Petroleum Engines Speed Control (Switch) - Test
2007/08/27 A New Temperature Gauge is Used {7450}
3512C Engine Plate Locations and Film Locations
3512C Engine Injector Solenoid - Test
C4.4 (MECH) Industrial Engine and Generator Sets Fuel Priming Pump and Fuel Filter Base - Remove and Install
C4.4 (MECH) Industrial Engine and Generator Sets Fuel Injection Lines - Remove and Install
C4.4 (MECH) Industrial Engine and Generator Sets Fuel Injector Cover - Remove and Install
C4.4 (MECH) Industrial Engine and Generator Sets Fuel Injector - Remove
C4.4 (MECH) Industrial Engine and Generator Sets Fuel Injector - Install
C4.4 (MECH) Industrial Engine and Generator Sets Fuel Injection Pump Gear - Remove
C4.4 (MECH) Industrial Engine and Generator Sets Fuel Injection Pump Gear - Install