Alternator - Remove
Start By:
- Remove the V-belts. Refer to Disassembly and Assembly, "V-belts - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Turn the battery disconnect switch to the OFF position.
- Make temporary identification Marks on the connections of the harness assembly.
Show/hide table
Illustration 1 g01255718 Typical Example - Disconnect the harness assembly from alternator (4).
- Remove bolt (6) from alternator (4).
- Remove nut (1) and washer (2). Remove bolt (5) from alternator (4). Remove alternator (4) from alternator bracket (3).
- If necessary, remove pulley (8) from alternator (4). Follow Steps 6.a and 6.b for the method in order to remove the pulley from the alternator.
Note: This method may not be suitable for some configurations of pulley.
- Hold the shaft of alternator (4) with an allen wrench. Use a cranked ring spanner (box wrench) in order to loosen nut (7).
- Remove nut (7) and pulley (8) from alternator (4).
Caterpillar Information System:
C3.3 Industrial Engine Fan Drive - Remove and Install
3500C Marine Engines Exhaust Manifold
C3.3 Industrial Engine Fan - Remove and Install
C3.3 Industrial Engine V-Belts - Remove and Install
C3.3 Industrial Engine Glow Plugs - Remove and Install
C3.3 Industrial Engine Crankshaft Gear - Remove and Install
C3.3 Industrial Engine Crankshaft - Install
C3.3 Industrial Engine Crankshaft - Remove
C3.3 Industrial Engine Crankshaft Main Bearings - Remove and Install - Crankshaft in position
C3.3 Industrial Engine Connecting Rod Bearings - Install - Connecting rods in position
C3.3 Industrial Engine Connecting Rod Bearings - Remove - Connecting rods in position
C3.3 Industrial Engine Pistons and Connecting Rods - Install
C3.3 Industrial Engine Alternator - Install
C3.3 Industrial Engine Electric Starting Motor - Remove and Install
3500C Marine Engines Exhaust Manifold
C32 Marine Propulsion Engines Sensor Signal (Analog, Active) - Test
G3408C and G3412C Engines Maintenance Interval Schedule - Standard
G3408C and G3412C Engines Maintenance Interval Schedule - Standby
C32 Marine Propulsion Engines Switch Circuits - Test
C18 Marine Generator Set Cooling System Coolant Sample (Level 1) - Obtain
C13 and C15 On-highway Engines Coolant Temperature Is Low
C7 On-highway Engine Exhaust Extension
G3520B Industrial Engines Air/Fuel Ratio Problem
C32 Marine Propulsion Engines Indicator Lamp - Test