Removal Procedure
Show/hide table
Table 1
Required Tools     |
Tool     |
Part Number     |
Part Description     |
Qty     |
A     |
267-2647     |
Stop Plug     |
1     |
B     |
9S-4180     |
Plug     |
1     |
Start By:
- Remove the air compressor. Refer to Disassembly and Assembly, "Air Compressor - Remove and Install".
Note: Cleanliness is a critical factor. Before you begin the removal procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Show/hide table
|
NOTICE |
Contact with high pressure fuel may cause personal injury or death. Wait 60 seconds after the engine has stopped to allow fuel pressure to purge before any service or repair is performed on the engine fuel lines. |
|
Show/hide table
|
NOTICE |
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Dispose of all fluids according to local regulations and mandates. |
|
Show/hide table
|
NOTICE |
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
|
Show/hide table
|
Contact with high pressure fuel may cause fluid penetration and burn hazards. High pressure fuel spray may cause a fire hazard. Failure to follow these inspection, maintenance and service instructions may cause personal injury or death. |
|
- Ensure that the No. 1 cylinder is at the top center compression stroke. Refer to Testing and Adjusting, "Finding Top Center Position for No. 1 Piston".
Show/hide table
|
|
|
Illustration 1 | g01365114 |
- Remove Tooling (B) and install Tooling (A) .
Show/hide table
|
|
|
Illustration 2 | g01365119 |
- Disconnect harness assemblies (1) .
- Disconnect tube assemblies (2) and (3) .
Show/hide table
|
|
|
Illustration 3 | g01365116 |
Show/hide table
|
|
|
Illustration 4 | g01365117 |
- Remove bolts (4) and remove bolts (6) .
- Remove bracket (5) .
- Remove nuts (8) and remove bracket (7) .
Show/hide table
|
|
|
Illustration 5 | g01365113 |
- Disconnect fitting (9) .
Show/hide table
|
|
|
Illustration 6 | g01365111 |
- Remove bolts (11) and remove the fuel injection pump (10) .